Fluidmaster 7115 Installation guide

STEP 3

STEP 4

READS

“THIS

SIDE

UP”

STEP 2

STEP 1

DO NOT USE:

INSTALLATION INSTRUCTIONS

:DEDEEN SLOOT

1. Separate snap-on insert from bolt cap.

2. Remove nut and washer from bolt located on base of bowl.*

With correct side up, place snap-on insert over thread of bolt.

3. Replace existing washer and nut.

4. Snap on bolt cap.

*To avoid removing nut and washer from floor bolts, fill bolt cap

with caulking or silicon sealant and position over floor bolt.

Follow instructions on caulking package. Discard snap-on

inserts.

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675 U.S.A.

www.xthistoilet.com

instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be

liable for any damages resulting from failure to install or maintain the product in accordance

with the product instructions, from abuse or misuse of the product, from use of

non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl

cleaners containing bleach or chlorine.

This manual is also suitable for

Download PDF