Installation Instructions
Subaru B9 Tribeca
Part Numbers:
44535
75401
87407
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 11/16, 3/4
Drill Bits: None
1. Lower the spare tire from the underside of the vehicle.
2. Remove the two (2) plastic fascia tabs (do not discard).
3. Using the 3/8 wire pull, insert the 3/8 Carriage bolts through the end of the inside portion of the vehicle bumper structure and
through the existing slots.
4. Raise hitch into position and loosely install 3/8 Conical toothed washers and 3/8 Hex nuts as shown above.
5. Using the ½ wire pull insert the ½ Carriage bolts and ¼ X 1.00 X 3.00 Blocks through the vertical holes in the vehicle frame
structure to the existing holes in the vehicle frame rails and through the receiver.
6. Install ½ Conical toothed washers and ½ hex nuts.
7. Tighten all fasteners to the required torque specifications.
8. Reinstall the two (2) plastic fascia tabs removed in installation step 2.
9. Raise spare tire back into position.
Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft.
Rev. B01-24-0675401NSheet 1 of 3
z 2005, 2006 Cequent Towing Products
½-13 X 2.00 GR5 Carriage BoltQty. (2)
4
½Hex NutQty. (2)
7
3/8 Hex NutQty. (2)
3
½ Conical Toothed WasherQty. (2)
6
3/8 Conical Toothed WasherQty. (2)
2
¼ X 1.00 X 3.00 BlockQty. (2)
5
3/8-16 X 1.25 GR5 Carriage BoltQty. (2)
1
Tighten all 3/8-16 GR5 fasteners with torque wrench to 30 Lb.-Ft.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75401F or 87407F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
3503500
Weight Carrying
Ball Mount
4004000
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV1, SUV2
Frame Structure
Bumper Structure
Fascia
Bumper Structure
Frame Structure
Spare Tire
Fasteners Typical Both Sides
Page is loading ...
Page is loading ...
/
