Assembly Instructions
BEFORE YOU BEGIN:
1. Identify all parts in the box against the “Parts” List.
2. Remove all protective material carefully and avoid cutting the surface of the furniture while removing
wrapped material.
Part
Description
Qty
Part
Description
Qty
A Table Top 1
D
Flat Washer 4
B
Base 1 E Lock Washer 4
C
Headless Bolt 4
F Nut 4
ATTENTION:
1. DO NOT use power tools or over-tighten hardware during assembly.*
*Aluminum is soft metal, so over-tightening may strip threads or break the parts.
2. Please read these instructions carefully before assembling.
3. During assembly, place furniture against soft surfaces to avoid scratching the paint/ metal.
Assembly Instructions
(FOR 201060-Q-B)
ASSEMBLY STEPS:
1. Place the TABLETOP (A) upside down onto a clean and soft, non-abrasive surface.
2. Screw the short side of the HEADLESS BOLTS (D) into the 4 holes of the TABLETOP.
3. Line up the holes of the BASE (B) with the TABLETOP and secure the parts together using FLAT WASHERS
(D), LOCK WASHERS (E), and NUTS (F).
4. Tighten all bolts and nuts completely.
5. Turn the table onto its legs.
6. If needed, you may use the adjustable feet to level out the table.
PROPANE TANK INSTALLATION:
1. Carefully open the door, and pull down the support bar for the propane tank.
2. Insert the propane tank lying on its side (as shown in the bottom left diagram), then raise the support bar back into
an upwards position.
3. Attach one end of the hose that connects to the propane tank and attach the other end that connects to the burner.
4. Turn on the propane tank before lighting the burner.
BURNER INSTRUCTIONS:
1. Before lighting the burner, make sure that the gas holes are not covered by glass or other decorative items (as
shown in the bottom right diagram).
2. Push in the knob, turn it halfway, and hold for approximately 15 seconds to allow the gas to flow through the
tube. Then, turn the knob all the way on.
3. Use a BBQ lighter to light the burner when turning the knob to the “On” position.
4. Once the flame is lit, then you can cover the burner with fire glass or other decorative items.
CARE INSTRUCTIONS:
Please DO NOT use acid or alkaline washing liquids to clean this product. Harsh cleaners can cause the
powder-coated finish to stain and fade. Use a soft towel with mild liquid soap and water to clean the product,
and dry with a soft cloth.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Hanover TRAD7PCFPBR User guide
-
Hanover MONDN5PCFP-BR Installation guide
-
Hanover TRAD4PCRECFP-BLU Installation guide
-
-
Envelor TRADITIONS4PCFP Installation guide
-
-
-
-
-
