Baby Brezza BRZ0057 Operating instructions

Brand
Baby Brezza
Model
BRZ0057
Type
Operating instructions

Baby Brezza BRZ0057 is an instant warmer that dispenses water at three temperature settings: room temperature, body temperature, and warmer than body temperature. It features a water container with a maximum fill line and a dispensing spout for easy and mess-free use. The LED indicator lights display the selected temperature and flash while the water is warming. The warmer is designed for household use only and should not be immersed in water or other liquids.

Baby Brezza BRZ0057 is an instant warmer that dispenses water at three temperature settings: room temperature, body temperature, and warmer than body temperature. It features a water container with a maximum fill line and a dispensing spout for easy and mess-free use. The LED indicator lights display the selected temperature and flash while the water is warming. The warmer is designed for household use only and should not be immersed in water or other liquids.

Cleaning
3©2022 Baby Brezza Enterprises LLC babybrezza.com
Before each use, hand wash Water Container and Lid in warm, soapy water, rinse and
dry thoroughly.
CAUTION: The Instant Warmer contains electronics. Exposing the electronics to water can
cause permanent damage not covered by the warranty.
Please take note of the following:
• Do not immerse the Instant Warmer in water or other liquid.
• Hand-Wash Only. Not Dishwasher-Safe. Using a dishwasher may damage the electronics
inside.
• Note: If the Instant Warmer is accidentally immersed and water gets inside, wipe with
a clean dry cloth and allow it to dry completely before next use.
• Base should be wiped with damp cloth only.
• Never use abrasive pads to clean the Instant Warmer parts.
Always unplug the Instant Warmer before cleaning.
Instructions
For set-up, use and cleaning
Please read fully to ensure your Instant Warmer works properly every time
Customer Service
If you are experiencing problems with your BabyBrezza product,
visit babybrezza.com/pages/international to locate your local customer service representative.
Distributed in Australia
by CNP Brands
82 Maribyrnong Street,
Footscray, VIC, 3011
Customer Service 1300 667 137
E: info@cnpbrands.com.au
W: www.cnpbrands.com.au
Distributed in New Zealand
by Wainhouse Distribution
2-6 Argyle St. Morningside,
PO Box 41-014
St Lukes, Auckland, New Zealand
Customer Service 0800 567 5000
E: [email protected]o.nz
Limited 1-Year Warranty
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality and the failure does not amount to a major
failure.
The limited warranty is valid only on products bought through authorized resellers. Buying through
an unauthorized reseller.
This warranty is available to consumers only. You are a consumer if you own a Baby Brezza product
that was purchased at retail for personal, family or household use. Except as otherwise required
under applicable state law, this warranty is not available to retailers or other commercial purchasers
or owners. We warrant that your Baby Brezza product will be free of defects in material or
workmanship under normal home use for one year from the date of original purchase. Customer
will be required to present original proof of purchase in order to obtain the warranty benefits. In
the event that you do not have proof of purchase date, the purchase date for purposes of this
warranty will be the date of manufacture. If your Baby Brezza product should prove to be
defective within the warranty period, we will repair it or, if we consider it necessary, replace it.
To obtain warranty services, please contact Customer Service.
NOTE: If the water is dispensing slowly from the spout, remove the water container lid and
wipe the condensation from the edge and inside rim of the water container. This will allow
the instant warmer to dispense at a normal rate.
IMPORTANT SAFEGUARDS
1 2
SAVE THESE INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be followed, including the
following:
1. Read all instructions before using.
2. Do not touch hot surfaces. Use handles or knobs.
3. To protect against electric shock do not immerse cord, plug or appliance in water or other liquid.
4. This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
5. Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
6. Children shall not play with the appliance
7. The use of accessory attachments not recommended by the appliance manufacturer may cause
fire, electric shock or injury.
8. Use on level surface and be sure there is no debris under the unit and the rubber pads are
touching the surface.
9. Household use only. Do not use outdoors.
10. Do not let cord hang over edge of table or counter, or touch hot surfaces.
11. Do not place on or near hot gas or electric burner, or in a heated oven.
12. Extreme caution must be used when moving an appliance containing hot liquids.
13. Do not use appliance for other than intended use.
14. If any misuse, such as putting liquid that other than water to the water container. It will create potential
injury from misuse.
15. After heating or all the water is removed from the water tank, the heater surface is subject to residual
heat after use.
16. Except cleaning, any other servicing should be performed by an authorized service representative.
17. Make sure machine is turned o before unplugging.
18. A short power-supply cord is provided to reduce risks of becoming entangled in or tripping over a
longer cord. Extension cords are available and may be used if care is exercised in their use.
19. If using the machine with an extension cord, make sure the cord is the proper electrical rating for
the machine. The marked electrical rating of the cord set or extension cord should be at least as
great as the electrical rating of the appliance. The extension cord should be arranged so that it
does not drape over counter top or tabletop where it can be pulled on by children or tripped over
unintentionally.
20. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is
dropped or damaged in any manner. Contact Baby Brezza Customer Service using the contact
information on the back cover for assistance.
TECHNICAL DATA Model: BRZ0057 Current: 0.69 A
Instant Warmer Parts
Get to know your Baby Brezza
Instant Warmer
1
2Plug in power cord.
Fill Water Container with as much water as you plan to use for the day. We recommend
refreshing the water every 24-48 hours and rinsing the Water Container every time it’s
refilled.
3
Touch the
Water Container
Lid
Dispensing Lever
Dispensing Spout
Water Container
MAX line
MIN line
Base
Power Cord
(not shown)
Blue, Yellow, Red LED light
Temperature Button
Power Button
button to choose your desired temperature.
4
Touch the button to turn on the instant warmer.
4
5
6
Place bottle under Dispensing Spout and press Dispensing Lever to dispense water.
Release lever to stop dispensing.
Add formula powder to bottle. Always follow formula manufacturer’s mixing ratio and
preparation instructions.
• Blue LED = heater o, room temperature
• Yellow LED = body temperature*
• Red LED = warmer than body temperature*
How to Use
Hand Wash Water Container & Lid before first use. See cleaning instructions on page 3.
• Never fill Water Container with formula
• Always use distilled or boiled water
cooled to room temperature
• Never pour boiling water into Water Container
• Always keep water filled above MIN Line
• Always keep the water tank covered with lid
to avoid contamination
The LED will flash while water is warming.
The LED will remain solid when water is warmed to selected temperature.
You can leave the Instant Warmer plugged in and set to your desired temperature so
warm water is always ready.
* Warming time may take 10-20 minutes depending on starting temperature of water
poured into water container.
A LWAYS use boiled, cooled water or bottled water suitable for infant formula preparation.
! WARNING:
Heater Power: 160WSupply Voltage: 220-240V ~ 50 - 60Hz
This marking indicates that products should not be disposed of with other
household wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use
the return and collection systems or Contact the retailer where the product
was purchased. They can take this product for environmentally safe recycling.
  • Page 1 1
  • Page 2 2

Baby Brezza BRZ0057 Operating instructions

Brand
Baby Brezza
Model
BRZ0057
Type
Operating instructions

Baby Brezza BRZ0057 is an instant warmer that dispenses water at three temperature settings: room temperature, body temperature, and warmer than body temperature. It features a water container with a maximum fill line and a dispensing spout for easy and mess-free use. The LED indicator lights display the selected temperature and flash while the water is warming. The warmer is designed for household use only and should not be immersed in water or other liquids.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents