1 2 4
35
P0510101**
YG40002
F401003
B40030101**
L01M5X6
ZS6.8**
ZS90628**
JQ54X3
LD-05010101
L05M8X20
R021.5004
T030045**
H050101
M24008
P0510101**
YG40002
F401003
B40030101**
L01M5X6
ZS6.8**
ZS90628**
JQ54X3
LD-05010101
L05M8X20
M24008
22
100 Min.
995
880
953
965
100
64--86
∅130
278
22
100
∅130
64--86
278
880
100 Min.
953
995
1/4
Service part
4/4
Mounting dimensions
Installation Instruction
Note
1. Be sure to flush the water supply pipe thoroughly to remove impurities in the pipe.
Ensure to clean the water supply pipe beforeinstallingtoavoidbeing jammed.
2. The cold-water supply must be connected on the rightandthehot-water supply on theleft.
3. Check theinstalling dimension according to theFigureandensureitis installed correctly.
4. Comply with local pipeline installation regulations.
5. The minimum operating pressure of the switch is0.05Mpa(0.5Bar).
6. Hot-waterinlet must not beover 80 C.
7.Maximum operating pressure of shower: 0.5 MPA (5 BAR). Pressure Relief Valves
shall be installed when water pressure exceeds 0.5 MPA (5 bar) . Maximum operating
temperature and ambient temperature of the shower:60 C
°
°
All information is compiled according to the latest published product information.
The company reserves the right to change product characteristics, packaging or
product types at any time without notice.
The manual includes important installation, maintenance and cleaning content,
please give these information to the user to read.
Instructions for use
Installation result check
Make sure all connections are tightened. Make sure the
handle is in the closed position. Use tools to remove the
bubble shell, frother and gasket. Remove the hand-held
shower, open the main water supply and check for leaks.
Open the hot and cold water valve so that water flows
through the outlet to remove debris. Switch to hand-held
shower, remove debris, clean screen gasket shutoff valve.
Re-install foam starter and hand-held shower heads.
Washing
Applicable to all processed surfaces: clean the plating surface with neutral soapy
water, and then thoroughly dry the entire surface with a clean soft cloth. Many
cleaning agents, such as ammonia, detergent and toilet cleaner, can cause
damage to the plating surface. Do not use it for injury.
Installation steps
Bath Mixer
3/4
2/4
The impurity or scaling in the spray hole will cause
the water flow deformation and decrease the flow
rate. Open the water source, press or Rub the rubber
spray hole to remove impurities or scale
Hand-held shower maintenance
Turn the handle gently, clockwise to cold water, counterclockwise to hot water.
Switch the initial position of the outlet water; gently lift the switch button,
shower water.
COOL
HOT
/
