Technika CP750SS User manual

Brand: Technika

Model: CP750SS

Category: Cooker hoods

Type: User manual

Technika CP750SS is a range hood designed to remove cooking odors and grease from the air. It features three speed settings, a light, and a timer. The aluminum grease filters are dishwasher safe for easy cleaning. The range hood can be installed in either the ducting or recirculating mode. In the ducting mode, the air is exhausted to the outside through a duct. In the recirculating mode, the air is passed through a charcoal filter and then recirculated back into the kitchen. The range hood is easy to install and comes with all the necessary hardware.

CP750SS

Instructions for Installation

Install Range Hoods in accordance with the manufacturer’s instructions.

Technika recommends that all Range Hood clearances be a minimum of

650mm to a maximum of 750mm (between the top of the cooking surface

and to the underside of the rangehood).

Distance may be reduced to 600mm to align with the AGA code.

LED lamp assembly LED lamp assembly

Fig.4 Fig.5

Fig.6 Halogen uni

Fig.7

GENERAL

Carefully read the f

ollowing important information regarding installation

safety and maintenance. Keep this information booklet accessible for

further consultations. The appliance has been designed for use in the

ducting version (air exhaust to the outside – Fig.A).

SAFETY PRECAUTION

1. Take care when the cooker hood is operating sim

ltaneously with an

open firepl

ace or burner that depend on the air in the environment and are

supplied by other than electrical energy, as the cooker hood removes the

air from the environment which a burner or fireplace need for combustion.

The negative pressure in the environment must not exceed 4Pa (4x10-5

bar). Provide adequate ventilation in the environment for a safe operation

of the cooker hood.

Follow the local laws applicable for external air evacuation.

Before connecting the model to the electricity netw

ork :

Check the data plate (positioned inside the appliance) to ascertain that the

voltage and power correspond to the network and the socket is suitable. If

in doubt ask a qualified electrician.

Do not check the status of the filters

while the Range Hood is

operating.

Do not touch bulbs or adjacent areas, during or straight after use.

Do not flambé under the Range Hood.

Disconnect the electrical plug prior to any maintenance.

This appliance is not intended for use by young children or infirm

persons without supervision.

Young children should be supervised to ensure they do not play

with the appliance.

There shall be adequate ventilation in the room when the Range

Hood is used at the same time as appliances burning gas or other

fuels.

There is a fire risk if cleaning is not carried out in accordance

with the instructions.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY

FOR DAMAGES CAUSED BY BREACHING THE ABOVE

WARNINGS.

INSTALLATION INSTRUCTIONS

Assem

bly and electrical connections must be carried out by specialized

personnel.

Electric Connection

The appliance has been manufactured as a class I, therefore earth cable is

necessary.

The connection to the mains is carried out as follow:

If not provided, connect a plug for the electrical

load indicated on the

description label. Where a plug is provided, the cooker hood must be

installed in order that the plug is easily accessible.

An Omni polar switch with a minimum aperture of 3mm between

contacts, in line with the electrical load and local standards, must be

placed between the appliance and the network in the case of direct

connection to the electrical network.

●The minimum distance between the trivets on the cooker top and th

lowest part of the cooker hood m

ust be at least 650mm and the highest

750mm .

Do not connect the cooker hood exhaust to the same Flue used to

circulate h

ot air or for evacuating fumes from other appliances generated

by other than an electrical source.

Before proceeding with the assembly operations, remove the anti-grease

filter(s) so that the unit is easier to handle.

In the case of assembly of the appliance in the suction version prepare the

hole for evacuation of the air.

USE AND MAINTENANCE

●It is recommended to operate the appliance prior to cooking.

It is recommended to leave the appliance in operation for15 minutes after

cooking is terminated in order to completely eliminate cooking vapors

and odor.

The proper function of the cooker hood is conditioned by the regularity of

the maintenance operations, in particular, the grease filters.

●The anti-grease filters capture the grease particles suspende

d in the air,

and are therefore subject to cloggi

ng according to the frequency of the

use of the appliance.

In order to prevent fire hazard, it is recommendable to clean the Grease

IEC227

L=live Brown

N=neutral Blue

E=earth Green/Yellow

filters at a regular interval of 2 months by carrying out the following

instructions:

- Remove the filters from the cooker hood and wash them in a solution of

water and neutral liquid detergent, leaving to soak.

- Rinse thoroughly with warm water and leave to dry.

- The filters may also be washed in the dishwasher.

The aluminum panels may alter in color after several washes.

This is not cause for customer complaint or replacement of panels.

Clean the oil cup on a regular basis by removing the grease filters and

sliding out the plastic cup.

●Clean the fan and other surfaces of the cooker hood re

gularly using a

cloth m

oistened with denatured alcohol

or non abrasive liquid detergent.

● Illum

ination installa

tion is designed for use during cooking and not for

prolonged general illum

ination. Prolonged use of the illumination

notably reduces the duration of the lamps.

Use a flat

blade screwdriver or any other appropriate tool to lift and

remove the overhead LED lamp fixture. Replace the faulty 1 watt LE

amp. Use only LED lamp assembly as the original specification;

Return the LED lamp fixture to its positi

on. (Fig.4) (Fig. 5)

● COM

ANDS:

(Fig.6)

A= OFF

B= SPEED I

C= SPEED II

D= SPEED III

E =LI

When pressing the key B, the display li

ght is flashing and please run in

SPEED 1.If you want to stop, you only press the key A.

When pressing the key E, the display light is flashing and then turn on the

light, If you want to turn off the light, you only press the key once again.

When the motor and the light work together or individually, press the key

A, and stop the activated functions of the timer automatically .The

display light is flashing countdown which will continue functioning for

15 minutes, and the motor and the lights will be turned off. For stopping

the timer, only press the key once again.

Manufacturers stated strictly that we refuse to take any responsibility

because of the results caused by any violation of the above procedures

Finding the pr

oblems and maintance.

Problem Possible reason Solution

Hood doesn’t work

No electric supply

Check the plug is connected

Check the main switch is turned on

Poor airflow Aluminum grease filters

clogged

Clean the filters and replace when

dry

Motor running but no

air flow

Butterfly valve jammed Contact technician

Motor cuts after a

few minutes

High temperature safety

device activated

The kitchen is not sufficiently

ventilated

The hood is installed too

near the cooking stove

The hood must be least 65cm from

stove

Oil dripping onto

stove

Oil cup full, missing or

not installed

Remove aluminum grease filter and

clean / refit oil cup

Aluminum grease filter

saturated

Wash the aluminum grease filters

Whirring sound Something in contact

with fan blade

Contact with technician

READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING THE APPLIANCE.

The manufacturer will not be responsible for any damage to property or to persons caused by incorrect installation or

improper use of the appliance.

The manufacturer is not responsible for any inaccuracies, due to printing or transcription errors, contained in this

handout. In addition, the appearance of the figures reported is also purely indicative.

The manufacturer reserves the right to make changes to its products when considered necessary and useful, without

affecting the essential safety and operating characteristics.

Technika constantly seeks ways to improve the specifications and designs of their products.

Whilst every effort is made to produce up to date literature, this document should not be regarded as an infallible guide.

Actual product only should be used to derive cut out sizes.

All Technika Appliances must be installed by a qualified person/s with adherence to the relevant electrical, plumbing and

AGA codes, with compliance being issued as required by state or national legislation.

Additionally all Technika Upright cookers must have chains installed correctly in adherence to the relevant AGA, and

plumbing codes by the Licenced installer.

For maximum effectiveness and efficiency all rangehoods should be installed with the use of ductwork, by a licenced

installer with adherence to the relevant state and national building codes and regulations.

All Technika appliances are for Domestic use only, and must be installed by a licence installer into Domestic Applications

only, without exception and to the required Authorities guidelines. Any installation outside of this will VOID warranty.

Alfresco areas are not a Domestic application.

TECHNI

Technika CP750SS User manual

Brand: Technika

Model: CP750SS

Category: Cooker hoods

Type: User manual

Download PDF

report

Technika CP750SS User manual

Technika CP750SS User manual

Related papers

Other documents