Algoma 4750BR Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Algoma 4750BR Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How many leg pieces are included?
    In which order should the uprights be attached?
    How many short bolts and washers are needed?
    What is the purpose of the clip hook?
    What is the maximum weight capacity of the stand?
    What should be done if hardware becomes compromised?
    How often should the stand be inspected?
    What are the care instructions for the stand?
    Where should the stand be stored when not in use?
C Frame Stand Assembly Instructions
Model Number 4750BR
*** Parts **
(A) Leg Pieces (2)
(B) Lower upright (1)
(C) Middle upright (1)
(D) Upper upright (1)
(E) Lock nuts (2)
(F) Long bolts (2)
(G) Short bolts (4)
(H) Washers (6)
(I) Clip hook (1)
(J) Wrench (1)
(K) Allen wrench (1)
(A)
(B)
(D)
(C)
(E) (F) (G)
(H)
(I)
(J) (K)
1. Locate the two leg pieces (A) and fit together as shown in Figure 1.
2. Insert a long bolt (F) through the bottom hole of the two leg pieces, and place a washer (H), and lock nut (E) on
end of bolt, and tighten so nut is just on the bolt. Figure 2.
3. Place lower upright (B) onto leg assembly, and insert second long bolt (F) through upper hole in leg assembly
and through aligned hole in lower upright piece. Attach washer (H) and lock nut (E). Now tighten both the
lower and upper bolts securely using the wrench (J) and Allen wrench (K), as in Figure 3.
4. Place middle upright (C) onto lower upright, aligning holes as in Figure 4. Insert short bolts (G) with washers
(H) into the two lower holes, and tighten using the Allen wrench (K) as in Figure 5.
5. Place the upper upright (D) onto the middle upright aligning holes as in Figure 6, Then insert short bolts (G)
with washers (H) into the two upper holes and tighten securely using the Allen wrench (K) as in Figure 7.
6. Attach clip hook (I) to loop towards the top of upper upright as in Figure 8.
7. Attach your hanging chair to the stand by clipping the O-ring of the chair into the clip hook.
CAUTION! Do Not Jump Or Bounce In The C-Frame Stand; Doing So May Cause Serious Injury
The C-frame has a maximum weight capacity of 275 lbs. Do not exceed maximum weight capacity. Always inspect hooks, hardware, and
make sure bolts are tightened securely before each use. If hardware has become compromised in any way, do not use the product as it may
be unsafe and using the stand could cause injury. Always inspect the overall condition of this product before each use. Never allow children
to use the C-frame stand without adult supervision.
Care Instructions:
For maximum life of this product, Algoma recommends putting the item indoors when not in use.
Clean the frame using a mild soap and water, scrubbing when necessary. Dry with cloth.
** DO NOT RETURN
TO RETAILER! **
Please call
customer service
for missing parts.
1-800-295-6758
2/12 Sun
-
djs
Figure 1 Figure 2 Figure 3
Figure 4
Figure 5 Figure 6
Figure 7 Figure 8
/