EXSYS EX-48030 Specification

EXSYS
Brand
EXSYS
Model
EX-48030
Category
Networking cards
Type
Specification
1
Congratulation on your purchasing this high performance Mini PCI
Express (Mini PCIe) Gigabit Ethernet card. The card is high speed PCI
Express bus based and plug-and-play compliant. It is compatible
with IEEE 802.3/u/ab and supports Jumbo Frame up to 9K bytes. It is
specially designed for any Embedded PC with a Mini PCIe
Express Card slot.
Features:
Full x1 Mini PCI Express Throughput, 250Mbytes/sec
Fully Compliant with PCI Express Base Specifications, Revision 1.1
Supports 1 Gigabit Ethernet Port Compatible with IEEE
802.3/u/ab
Supports Microsoft NDIS5, NDIS6 Checksum Offload (IPv4, IPv6,
TCP, UDP) and Segmentation Task-offload (Large send v1 and
v2)
Supports Win98SE, ME, 2K, XP, XP64, Vista, Win7 and Linux
Mini PCIe Card:
RJ45 Daughter Board:
EX-48030
Gigabit Ethernet Mini PCIe Card
1. Introduction
2. Board Layout
J3: LED connector
(to RJ45 daughter board with a cable)
Mini PCIe
golden
fingers
Pin #1
J2: Gigabit Ethernet Port
(to RJ45 daughter board with a cable)
Pin 1
Gigabit Ethernet Mini PCIe Card
2
1. Remove the Mini PCIe card from its protective antistatic
packaging. Install LAN and LED Cables on the J2 and J3 of Mini
PCIe card. Connect them to RJ45 daughter board’s J5 and J4
respectively.
2. Remove the screw holding the Mini PCIe card to the
motherboard and insert the new Mini PCIe card into the socket.
3. Installing the Mini PCIe Card
Pin #1
J5:
Gigabit Ethernet Port
(to Mini PCIe card with a cable)
J4:
LED connector
(to Mini PCIe card with a cable)
Yellow LED: LINK/ACT
Steady On: Linked
Blinking: Transferring Data
Green LED:
On:
Gigabit Mode
LAN Cable
LED Cable
Gigabit Ethernet Mini PCIe Card
3
3. Put the Mini PCIe card onto the motherboard and attach it with
the screw.
4. The daughter board’s built-in bracket can be mounted directly
to your computer rear panel or with an optional PCI-type
bracket. The normal PCI and low profile brackets are optional,
they may not be included in the package box and should be
ordered separately.
Mini PCIe Socket
Holding screw
Gigabit Ethernet Mini PCIe Card
4
The Gigabit Ethernet drivers are shipped in the following folder of the
driver CD.
Please browse to the corresponding driver folder when Windows ask
you to specify the driver location. Then follow the on-screen
instructions of the Windows to complete the installation.
You can use Device Manager to check the installation. Here is the
screen shots showed you that it was installed correctly:
4. Software Installation
Gigabit Ethernet
port shown here
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

EXSYS EX-48030 Specification

EXSYS
Brand
EXSYS
Model
EX-48030
Category
Networking cards
Type
Specification
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents