7
RECEIVER PANEL DESCRIPTION
GB Equalization Trim Pots
Trim Potentiometers
Ad
usts the Red,
reen, and Blue color components to correct color
onver
ence
diver
ence due to var
in
distances and
or skew variations
ound
in di
erent brands o
AT-
cable. Turn the controls to achieve the best color
and picture.
ee pa
e 11
or details.
When turning the Trim Pots, use a small screwdriver or an electronic
device ad
ustment tool
available at electronics stores
. Use
entle
orce when
otatin
Trim Pot controls. Turn controls in both directions i
necessar
to
et
best results. Never
orce a control i
resistance is encountered.
e
en is not
esponsible
or inoperable units due to broken trim pot controls.
Brightness Trim Po
Ad
usts the bri
htness o
the picture.
Focus Trim Po
Ad
usts the
ocus o
the picture.
ower Indicator LED
This LED will turn RED once the lockin
power suppl
has been properl
nn
t
When the
AT-5 link is established, the LED will be
REEN. When
the Receiver unit is in
tandb
Mode or Power
avin
Mode, this LED will be
ED.
Power
avin
Mode is covered in detail on pa
e 9
.
5V DC Locking Power Connector (threaded jack on rear left of Receiver)
onnects the included 5V D
Lockin
Power
uppl
here.
crew in the lockin
ower connector with hand
orce onl
until it stops turnin
. Do not overti
hten.
GA Outputs
2 x HD15 Connectors
onnect V
A monitors to these ports.
Audio Output Connector
3.5mm Mini-Stereo
onnect the audio
rom this port to an analo
audio ampli
er.
AT-5 Video Link Input
RJ-45 Connector
onnects the
ender unit to the Receiver unit usin
AT-5 cable. Used to
eceive the video si
nal
rom the
ender Unit.
USB Ports (4 x USB 2.0 type “A”)
onnect the U
B devices
ke
board, mouse device, etc.
to these ports. The
AT5-1600A Receiver
unctions as a 4-port U
B 2.0 Hub.
AT-5 USB Link Input
RJ-45 Connector
eceives the U
B si
nals
rom the
ender Unit.
onnects to the Receiver unit
via a len
th o
AT-5 cablin
.
Host Indicato
This LED will turn
REEN when the power and all devices are connected to
the
ender unit. The LED will turn RED i
a
B device or monitor has been
disconnected
rom the
ender unit.