2. Computers & electronics
  3. TVs & monitors
  4. Flat panel wall mounts
  5. Chief
  6. LSM5364

Chief LSM5364 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Chief LSM5364 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What should I do if any parts are missing from the kit?
    What is the purpose of the universal washer?
    What are the dimensions of the nylon spacer?
    What size are the Phillips Pan Head screws?
    How do I attach the interface brackets to the back of the display?
    What should I do if I need to use longer screws?
    What is the warning about over-tightening screws?
    What is the recommended way to install the interface brackets?
INSTALLATION INSTRUCTIONS
FHB-3364 / FHB-5364
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of
Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8800-002019 Rev00
©2009 Milestone AV Technologies,
a Duchossois Group Company
www.chiefmfg.com
06/09
The FHB hardware kits are designed for use with Chief® Series
Mounts. See the specific installation instructions provided with the
mount for additional installation information.
Unpack and verify kit contents. If any listed parts are missing,
immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY AND DAMAGE TO EQUIPMENT! DO NOT substitute
hardware. Use only hardware supplied by manufacturer!
PARTS
WARNING: OVER TIGHTENING OF SCREWS CAN
DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL
INJURY AND DAMAGE TO EQUIPMENT! DO NOT over
tighten screws when installing interface brackets.
NOTE: Properly sized screws will easily and completely thread into
display mounting holes. If spacers are required, be sure to
use longer screws of the same diameter.
®Chief is a registered trademark of Milestone AV Technologies. All rights reserved.
NOTE: The provided fasteners should be used with the universal
washer (A) as noted. (See Figure 1)
Figure 1
1. Attach interface brackets to back of display using the provided
hardware, and noting where the centerline of display should be
located against the interface bracket. (See Figure 2)
Figure 2
2. Continue installation following the instructions included with the
mount.
(Qty) Description
A
(4) Universal Washer
B
(4) Spacer, Nylon, .75 x .26 x .375
C
(4) Screw, Phillips Pan Head, M6 x 25mm
D
(4) Screw, Phillips Pan Head, M6 x 16mm
A (4)
Universal
Washer
B (4)
.75 x .26 x .375
C (4)
M6 x 25mm
D (4)
M6 x 16mm
M4 (not included)
M5 (not included)
M6
Universal
Washer
Centerline
of Display
/