Duratrax Warhead Forward-Only Kit User manual

Duratrax
Brand
Duratrax
Model
Warhead Forward-Only Kit
Category
Toy vehicles
Type
User manual

This manual is also suitable for

Duratrax Warhead Forward-Only Kit is a useful tool for those looking to upgrade their RC car. It allows you to remove the reverse gear from your transmission, which can improve performance and speed. The kit includes all the necessary parts and instructions for installation. With this kit, you can easily convert your RC car to forward-only operation, giving you a competitive edge on the track. Whether you're a beginner or an experienced RC enthusiast, the Duratrax Warhead Forward-Only Kit is a great way to improve the performance of your car.

Duratrax Warhead Forward-Only Kit is a useful tool for those looking to upgrade their RC car. It allows you to remove the reverse gear from your transmission, which can improve performance and speed. The kit includes all the necessary parts and instructions for installation. With this kit, you can easily convert your RC car to forward-only operation, giving you a competitive edge on the track. Whether you're a beginner or an experienced RC enthusiast, the Duratrax Warhead Forward-Only Kit is a great way to improve the performance of your car.

DuraTrax
®
Warhead
™
Forward-Only Kit
Required tools: Phillips screwdriver, 2.5mm hex wrench and 2mm hex wrench.
Tip: During installation of the forward-only shaft, inspect all of the transmission
parts for wear so that they can be replaced if required.
1. Remove the transmission from the chassis.
2. Remove the screw pin (PP) from the diff
output (116).
3. Remove the shift fork lever horn (131) from
the reverser slider plate (160).
4. Remove the screws (TT) from the
transmission case and separate the two
halves. Tip: Remove the case halves slowly
to help prevent losing any parts.
5. Remove all of the parts from the center
transmission shaft (123). Tip: Lay all of the
parts out on your work surface in the order
they came off.
6. Remove the brake assembly (128,129,166 and Q) from the
transmission case.
7. Remove the screw pin (PP) from the rear transmission drive joint
(127) and remove the joint from the transmission shaft (123).
8. Install the forward-only shaft into the transmission case (124).
9. Re-install the rear transmission drive joint (127) and secure it
in place by re-installing the screw pin (PP). Tip: Place a small
amount of threadlock on the screw pin before installing into the
drive joint.
DTXZ2565 for DTXC4547
Copyright © 2007
10. Re-install the brake assembly onto the transmission case half (124). Tip: Check the brake
pads for wear. This is a good time to replace them if needed.
11. Remove both of the 4x5mm set screws (J) from the clutch. IMPORTANT: Do not remove
the angled shift point adjustment set screw.
12. Remove the second gear plate (167) from the second gear housing (120) and remove the
two speed clutch (119).
13. Re-install the two speed clutch (119) into the second
gear housing (120). IMPORTANT: The side of the
clutch with the lip goes on the shaft fi rst.
14. Re-install the second gear plate (167) to the second
gear housing (120).
15. Re-install the two speed assembly onto the forward-only shaft.
16. Install the screw pin (included with the forward-only shaft) into the two
speed clutch and through the hole in the forward-only shaft. Then, install
one of the 4x5mm set screws to help secure the screw pin in place.
Note: The screw pin takes the place of the one of the 4x5mm set screws
and secures the two speed assembly to the forward-only shaft.
17. Re-assemble the transmission assembly and install back into the chassis.
Tip: You can remove the shift servo from the chassis to reduce weight.
  • Page 1 1

Duratrax Warhead Forward-Only Kit User manual

Duratrax
Brand
Duratrax
Model
Warhead Forward-Only Kit
Category
Toy vehicles
Type
User manual
This manual is also suitable for

Duratrax Warhead Forward-Only Kit is a useful tool for those looking to upgrade their RC car. It allows you to remove the reverse gear from your transmission, which can improve performance and speed. The kit includes all the necessary parts and instructions for installation. With this kit, you can easily convert your RC car to forward-only operation, giving you a competitive edge on the track. Whether you're a beginner or an experienced RC enthusiast, the Duratrax Warhead Forward-Only Kit is a great way to improve the performance of your car.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents