WattBox WB-ACC-TRIGGER Owner's manual

INSTALL GUIDE

WB-ACC-TRIGGER

The WattBox Trigger provides users with an easy way to cycle power on any or

all of the outlets on a WB-IP device.

Package Contents

• WattBox Trigger (normally open, momentary closed) switch with adhesive

backing

Installation

Position the switch in the desired location, then connect to the “REMOTE

TRIGGER” port on the WattBox using the phoenix connector included with the

IP device. Then log into the WB-IP interface to enable the trigger port and select

which outlets to power cycle.

Remote trigger

on the WattBox

Phoenix

connector

Extend wiring

up to 45'/13.7m

using Cat5 or other

conductors 24AWG

or larger. Wires can

be connected either

way (no polarity).

Warranty & Regulatory

Find details of this product’s 2-Year Limited Warranty at snapav.com/warranty,

or request a paper copy from Customer Service at (866) 424-4489. Find other

legal resources, such as regulatory notices and patent information, at

snapav.com/legal.

Technical Support

Phone: 866.838.5052

Email: TechSupport@SnapAV.com

are registered trademarks or trademarks of Wirepath Home Systems, LLC, dba “Control4” and/or dba “SnapAV” in the

United States and/or other countries. 4Store, 4Sight, Control4 My Home, Snap AV, Araknis Networks, BakPak, Binary,

Dragony, Episode, Luma, Mockupancy, Nearus, NEEO, Optiview, OvrC, Pakedge, Sense, Strong, Strong Evolve, Strong

Versabox, SunBriteDS, SunBriteTV, Triad, Truvision, Visualint, WattBox, Wirepath, and Wirepath ONE are also registered

trademarks or trademarks of Wirepath Home Systems, LLC. Other names and brands may be claimed as the property of

their respective owners. All specications subject to change without notice.

210224-1322