Elba EPAC-D3910 Owner's manual

Brand: Elba

Model: EPAC-D3910

Type: Owner's manual

MODEL EPAC-D3910WH

CONTENT

SAFETY PRECAUTIONS..............................................................2

PRODUCT DESCRIPTION………………………………………...3

INSTALLATION..........................................................................4-5

CONTROL SETTING.....................................................................6

OPERATING INSTRUCTION.....................................................7-8

DRAINAGE METHOD………………………….…………….……….8

CLEANING AND MAINTENANCE.................................................9

SEASONAL CLEANING………...................................................10

INTELLIGENT ERROR DETECTION……………………..………10

TROUBLESHOOTING.............................................................…..10

MAIN SPECIFICATION....................................................................11

REMOVE ALL PACKING MATERIALS FROM THIS PRODUCT BEFORE USING IT. THIS

APPLIANCE MUST BE INSTALLED ON A FLAT SURFACE. PLEASE ENSURE THE

ELECTRICITY SUPPLY TO THIS APPLIANCE IS DISCONNECTED BEFORE INSTALLING.

Please read this instruction carefully. It is advisable to keep this instruction manual in a safe

place for future reference.

SAFETY PRECAUTIONS

1. Keep this appliance out of reach from children. Do not let them to operate the appliance

without supervision.

2. Check the current rating on the rating plate and make sure the current supplied is

matched with the appliance before using.

3. This product is for household and indoor use only.

4. This product is not intended for use by person (including children) with reduced physical,

sensory or mental capabilities unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

5. If the power cord or plug is damaged, it must be replaced by the service centre or a

qualified service technician to avoid hazard.

6. This product should not be placed near possible heating resources or under direct sunlight

to avoid decreasing the efficiency of cooling.

7. Always turn off and unplug the appliance before moving, cleaning or when it is not in used.

Do not leave the appliance to operate unattended.

WARNING – To reduce the risk of fire or injury to person or property, please read and

follow below instruction carefully:

 Do not operate this appliance if it has malfunctioned, damaged or appears damaged in

any way. Make enquiry to our service centre and return the complete set to the place of

purchase for inspection, repair or replacement.

 Do not insert your finger or any object into the wind inlet or outlet.

 Do not attempt to carry out repair on the appliance by yourself. Seek for a qualified service

technician or send to the authorised service centre for repair.

 Place the appliance on flat ground and install it vertically, so as to ensure normal operation

of the compressor.

 The appliance should be at least 50cm away from surrounding objects. Make sure air inlet

and outlet are not blocked.

 Do not use the appliance near gasoline or any other flammable liquids.

 Do not use spraying agent or flammable substances near the appliance; otherwise its

plastic may deform and electrical parts may be damaged.

PRODUCT DESCRIPTION

1. Control panel 15. Air outlet

2. Horizontal louver 16. Wire-winding post

3. Vertical louver 17. Drain cap

4. Air outlet frame 18. Evaporator filter mesh

5. Vertical louver lever 19. Evaporator filter frame

6. Caster 20. Radiating fine mesh

7. Top panel 21. Condenser filter mesh

8. Horizontal louver lever 22. Condenser filter frame

9. Vertical louver 23. Base plate

10. Front panel 24. Remote control

11. Handle 25. Circular connector

12. Back panel 26. Ex

haust hose

13. C shape buckle of the heat exhaust 27. Window sealing plate

14. Power cord 28. Exhaust hose connector

INSTALLATION

Installing the Appliance

 Settle the appliance in an upright position for at least 2 hours before first use.

 Always move the appliance in the upright position.

 Do not install or operate this air-conditioner in a bathroom or other wet environments.

 Place it on a flat and even place, keep it at least 50cm away from its surrounding object.

 Lift up the C shape buckle of the heat exhaust gently from the rear of the appliance.

 Insert the exhaust hose at the air outlet and make sure it sits properly onto the air outlet by

turning few rounds clockwise.

 Secure the exhaust hose by turning the C shape buckle of the heat exhaust gently. Fasten

the clip of the buckle until it clicks with the trigger.

 The end of the exhaust hose must reach one step inside the bottom part of the air outlet.

 Hold the unit with one hand and pull the exhaust hose from the appliance to extend the

length of the exhaust hose. Be careful not to tilt the appliance when pulling the exhaust

hose.

 Insert the circular connector onto the exhaust hose properly by turning few rounds

clockwise.

Installing the Window Sealing Plate

 Half open the window and mount the window sealing plate onto the window, either

vertically or horizontally.

 Adjust the opening width of the window so that the window can match with the sealing

plate properly. The length of the sealing plate is also adjustable.

 Fasten the window sealing plate assembly with screw.

 Insert the ducting circular connector onto the elliptical hole on the window sealing plate.

The exhaust hose must not be bent and shall be less than 45º flexure.

 The exhaust hose is design to fit the appliance with the length of 280mm to 1500mm.

 Do not use prolonged exhaust hose or replace with other different hoses as it may affect

the performance of the appliance. The appliance may overheat if the exhaust hose is

obstructed.

CONTROL SETTING

This appliance has three modes: Cooling, Dehumidifying and Fan. The fan has two speeds.

The temperature setting is from 17ºC to 30ºC (62ºF to 86ºF).

1. ON/OFF button

Press this button to turn ON/OFF the appliance.

2. Mode button

Press this button to choose Cooling, Dehumidification and Fan mode when the appliance is

working or Timer on.

3. Fan Speed button

Press this button to select the fan speed of Low and High. This function is not available in

Dehumidifying mode.

4. Timer button

Press this

button to activate Timer-On function in standby mode. When setting the time, the

timer indicator will light and the corresponding timer will illuminate. Press Up and Down button

to increase or decrease the hour from 1 to 24 hours at one hour interval.

When the appliance is in operating condition, press this button to activate Timer-Off function

using the same operating instruction.

5. Temperature/ time Adjusting (Up/Down) button

Press this button during cooling mode to increase/decrease the t

emperature;

Press it at timer mode to adjust timer;

Press Up and Down keys simultaneously to switch Fahrenheit and Centigrade degree

temperature.

This function is not available in Dehumidifying mode.

Timer

indicator

LED

Display

6. Temperature / Time Display Window

This window displays the adjusted temperature and time. When idle, it shows the room

temperature.

7. Sleep Mode Indicator

This indicator light will turn on when the sleep mode is activated. To activate the sleep mode,

press the Timer and Down button simultaneously (Refer Sleep Mode).

8. Water Full Indicator

This indicator light will turn on when the condensation water is full in the appliance. The

appliance may turn off momentarily until the water has been drained off from the outlet (Refer

Drainage Method).

9. High / Low Indicator

This indicator light will turn on when the corresponding fan speed is selected.

OPERATING INSTRUCTION

In Cooling Mode

 When the set temperature is greater than the room temperature by 1ºC (1ºF), the

compressor will start operating.

 When the set temperature is lower than the room temperature by 1ºC (1ºF), the

compressor will stop, only the fan remains operating.

In Sleep Mode

 Press the Timer and Down button simultaneously and the sleep mode will be activated.

 After operating for two hours, the set temperature will increase by 1ºC (1ºF) automatically.

 After operating for four hours, the set temperature will further increase by 1ºC (1ºF).

 The fan speed will be switched to Low automatically.

In Dehumidification (Dry) Mode

 In Dry mode, if the room temperature ≥ 17ºC (62ºF), the compressor will start.

 When the room temperature ≤ 15ºC (59ºF) the compressor shuts down.

 When the room temperature rises to be ≥ 17ºC (62ºF), the compressor starts again.

 There will be a 3-minute protection delay for the compressor.

 In dehumidification mode, the fan is defaulted to run at low speed, and wind speed cannot

be adjusted. Temperature cannot be set.

In Fan Mode

 In Fan mode, the fan runs on either Low speed or High speed.

 The temperature setting is not available in this mode.

 The room temperature will display between 10–35ºC (50-95ºF).

Timer mode

 In standby state, press the timer key to set ON timer. Press Up and Down keys to set ON

timer (0~24H), and the timer indicator lamp lights up.

 In operating state, press the timer key to set OFF time. Press Up and Down keys to set

OFF timer (0~24H), and the timer indicator lamp lights up.

 The timer can be set at every 1 hour interval.

Remote Control Operating Instruction

The operation of the remote control is as follow:

 Power Button: Press this button to turn on/off the appliance.

 Timer Button: Press this button to activate timer on/off function. The timer will illuminate

while pressing the Up and Down button can set the desired on/off timer.

 High Button: Press this button to select high fan speed.

 Low Button: Press this button to select low fan speed.

 Up / Down button: Press this button to select the temperature / timer.

 ºC/ºF Button: Press this button to switch between ºC and ºF temperature display.

 Cool Button: Press this button to operate in cooling mode.

 Dry Button: Press this button to operate in dehumidification (dry) mode.

 Fan Button: Press this button to operate in fan only mode.

 Sleep Button: Press this button to activate sleep mode.

DRAINAGE METHOD

This appliance is equipped with automatic water vaporization system. The condenser is cooled with

the circulating of condensing water to improve cooling efficiency and energy saving.

 If the internal water tank is full of water, the water full indicator will turn on, and the

compressor stops operate automatically. Switch off the power and unplug the appliance.

 Move the appliance carefully to avoid spillage of water from the tray at the bottom of the

appliance.

 Prepare a container to contain water below the water outlet at the rear of the appliance.

 Remove the drainage cap by turning it counter-clockwise. Unplug the rubber plug and the

water will flow out from the appliance to the container.

 Once the water has been fully drained, insert the rubber plug and fasten the drainage cap.

NOTE: Please carefully remove the rubber cap and take care of the drainage cap properly.

Always tighten the rubber plug and drainage cap before operating the appliance.

Rubber

plug

Drainage

cap

NOTE: Please pay extra attention when withdrawing the filter frame and filter mesh. Do not

apply excessive force as it will damage the evaporator fins or the filter mesh.

 Put the filters into lukewarm water with mild cleaner and dry it under the shades. Avoid

brushing with metal brush or damage the filters.

 Put the filter screen into lukewarm water (about 40ºC ) added with neutral detergent, dry it

completely under a shady place after cleaning.

 Install the filters back into its original position after cleaning.

SEASONAL CLEANING

If the appliance will not be used for a long time:

 Turn off the appliance and remove the drainage cap and rubber plug to drain off the remaining water.

 Turn on the appliance and operate the appliance in wind mode for 2 hours until the internal is dry.

 Turn off the appliance and unplug from electrical mains.

 Wash the filter screen and reassemble it.

 Dismantle the exhaust duct and keep it properly.

 Cover the appliance with a proper bag and store it at a dry place.

INTELLIGENT ERROR DETECTION

Error-detecting code

Multi-functional defection

Pipe temperature sensor failure

Room temperature sensor failure

Anti-freezing protection: Temperature of the coil is too low and the appliance

will be turned off. When temperature rises above 8ºC , the protection is

released and previous working state will be recovered.

TROUBLESHOOTING

In case of any of the following trouble, please contact service centre for assistance.

Fault Indication

Cause

Solution

The appliance

doesn’t operate

Plug not connected

Connect the plug to the electrical mains

and switch on the power.

The water full indicator

illuminates

Restart the appliance after power off and

draining, then it will become normal.

The appliance starts

frequently

Doors and windows keep

open; there are lots of heat

sources in the room

Close doors and windows, remove heat

source.

Filter screen is very dirty

Clean or replace it.

Air inlet or air outlet is blocked

Remove the blocking item.

Loud noise of the

appliance

The appliance is placed

unevenly

Place it at even and firm ground, avoid

shaking.

The compressor

doesn’t work

The overheat protection is

activated

Wait for 3 minutes, turn on after

temperature decreases.

Notice: When there is any abnormal operating condition to the appliance, turn it off and unplug from

electrical mains, contact service centre for maintenance.

MAIN SPECIFICATION

Model No : EPAC-D3910(WH)

Cooling Capacity : 10,000 BTU/h

Thermostat Range : 17ºC to 30ºC (62ºF to 86ºF).

Max Air Flow : 380m

Rated Voltage : 220-240V

Rated Frequency : 50Hz

Rated Input Power : 999W

Refrigerant : R410a

NOTICE

This product must not be disposed together with domestic waste. It has to be disposed at an

authorized place for recycling of electrical and electronic appliances. By collecting and

recycling waste, you help to save natural resources and make sure the product is disposed in

an environmental friendly and healthy way.

Elba EPAC-D3910 Owner's manual

Elba EPAC-D3910 Owner's manual

Elba EPAC-D3910 Owner's manual

Related papers

Other documents