Netgear RBK752 User manual

Welcome to your new

Orbi Wi-Fi 6 router

What’s in the box?

1x NETGEAR Orbi Wi-Fi 6 router 1x Power adapter 1x Ethernet cable

Download the

Orbi app

Connect your

Orbi router

1. Connect the Ethernet cable to your Orbi’s Internet port, then connect

the other end to the port labelled LAN1 or GE1 on your Optical Network

Terminal – that’s the fibre box usually found on your wall.

2. Connect the power adapter and turn your Orbi on at the wall.

Got extra Orbi satellites? Find a place to plug them in now, or you can set

them up later. Orbi satellites must be within range of your Orbi router’s Wi-Fi

signal, so don’t place them too far apart from each other.

If you have a landline, connect it to the port labelled POTS or TEL on your

Optical Network Terminal.

LAN TEL

ONT

Connect to your

Orbi Wi-Fi network

1. Go to the Wi-Fi settings on your mobile device.

2. Connect to your Orbi Wi-Fi network. You’ll find the Wi-Fi network name

and password printed on the front of your Orbi router.

It may take a few minutes for your network to appear after

plugging in your Orbi.

Open the Orbi app

and follow the

setup instructions

Important: Skip the steps instructing you to disconnect and reconnect your

ISP modem. These steps don’t apply – just select ‘Continue’.

That’s it, your Orbi router is up and running!

For NETGEAR’s Privacy Policy, visit www.netgear.com/about/privacy-policy.

By using this device, you are agreeing to NETGEAR’s Terms and Conditions at

www.netgear.com/about/terms-and-conditions. If you do not agree, contact

Slingshot at www.slingshot.co.nz/contact to return your device.