Midland Radio MXAT03 Installation guide

I have analyzed the Assembly Diagram for the Midland Antenna MXAT03. This document details the installation process, specifications, and component list, including a mounting stud, optional spacer, mounting surface, washers and hex nut. I'm ready to help answer your questions about the MXAT03 Antenna and its assembly.
What is the maximum thickness of mounting surface?

What size hole is required for installation?

When is the 3/8" spacer needed?

What is the maximum torque for the hex nut?

5900 Parretta Drive ● KANSAS CITY, MO ● 64120

PHONE: (816) 241-8500 ● FAX: (816) 241-5713

WEBSITE: midlandusa.com

Midland Radio Corporation

midlandusa.com

4/26/2023

MXAT03 Assembly Diagram

1. The MXAT03 is designed for mounting brackets or surfaces up to 1/2" thick.

2. The MXAT03 is designed to be installed in a 1/2" hole.

3. Part B, 3/8” spacer, is optional for mounting brackets or surfaces up to 1/8” thick. Part B, 3/8” spacer,

should be removed for brackets or surfaces more than 1/8” thick.

4. Remove the FME to PL259 adapter on the end of the coaxial cable so the washers and hex nut can be slid

off the coaxial cable. Also remove the 3/8” spacer, Part B, if not being used.

5. Route the coaxial cable from the topside through the mounting hole in the bracket or surface, Part C.

6. Slide the flat washer, lock washer and hex nut, Parts D, E and F, back on the coaxial cable in the order

shown.

7. Hold the antenna assembly in position while tightening the hex nut, Part F. Maximum torque 35 lb-ft.

8. Finish routing the coaxial cable through the vehicle to the radio, before reinstalling the FME to PL259

adapter.