Spectrum Industries 55514UW, 55514B, 55514WG, Shelf, Shelf SLIM Lectern Owner's manual

  • I have reviewed the assembly instructions for the Spectrum 55514 additional shelf for the Slim Lectern. This document explains how to install the shelf, including the necessary parts, tools, and steps. I can help you with any questions about assembling this shelf.
  • What should I do if I find a damaged part?
    What screws are used for metal side panels?
    What screws are used for wood side panels?
0191459 Page 1 of 1
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
© 2019 Spectrum Industries Inc., All rights reserved.
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
Tools
Required
Installation
Additional Shelf
for Slim Lectern
55514
Phillips
Screwdriver
(1) 0145953
Shelf
(1) 059984
2” Grommet
(4) 0190174
#8 x 3/8” PHSM
1. Install (2) #8 x 3/8” PHSM screws in the back panel at the desired height of the shelf.
Install screws about halfway-this will allow the shelf keyholes to be used. Figure 1.
2. Set the the shelf onto the screws and install the (2) instructor-side screws using the
pre-drilled side panel holes. (2) #8 x 3/8” PHSM for metal side panels, or (2) #8 x
5/8” PHSM for wood side panels. Be sure the shelf sits level.
3. Tighten all screws securely.
4. Install 2” grommet.
Figure 1
Side panel
(2) #8 x 3/8” PHSM (for metal side panels)
(2) #8 x 5/8” PHSM (for wood side panels)
Shelf
2” Grommet
(2) 037542
#8 x 5/8” PHSM
(2) #8 x 3/8” PHSM
/