Signia CHARGER BTE P User guide

Type
User guide

This manual is also suitable for

Charger BTE P/SP & RIC
User Guide
2
Content
Before you art  4
Components    6
Connecting the USB power cable    7
Charging  8
Correct position of the hearing inruments     11
Charging atus    12
Charging tips    13
Further information  20
Maintenance and care    20
Troubleshooting    21
3
Important safety information  24
General warnings    24
Personal safety    26
Product safety    31
Important information  33
Explanation of symbols    33
Operating, transport, and orage conditions    35
Technical data of the power supply adapter    37
Disposal information    37
Conformance information    38
Country-specic information    40
4
Before you art
This device is intended to charge our specic hearing 
inruments with built-in power cells (lithium-ion 
rechargeable batteries). Your Hearing Care Professional will
advise you on the compatible models.
The charger is only intended for indoor use. Observe
and follow the operating conditions in section
"Operating, transport, and orage conditions". 
The charger is not intended as a means of orage for 
transportation of hearing inruments.
5
CAUTION
Read this user guide thoroughly and completely and
follow the safety information in this document to avoid
damage or injury.
The device may not look exactly like the guiding
illurations in these inructions. We reserve the right 
to make any changes we consider necessary.
6
Components
Status LEDs
Charging slots
Non‑detachable USB power cable
Power adapter
7
Connecting the USB power cable
XConnect your USB power cable to the provided power
adapter.
8
Charging
NOTICE
Please make sure that the power plug is easily
accessible to remove it from power supply if
necessary.
XConnect the charger to the power supply.
LEDs for each charging slots blink 3 times to indicate that 
the charger has power and is ready for use.
9
XPut the hearing
inruments in the 
charging slots as shown
in the picture. You can
charge both hearing
inruments at the same 
time.
The hearing inruments 
are automatically turned
o and art charging. 
The charging atus 
is indicated, see table
"Charging atus" on the 
next pages.
10
X
When you want to use your hearing inruments, take 
them out of the charger. They will automatically turn on.
XYou can leave the charger plugged in or remove it from
the power supply.
11
Correct position of the hearing inruments
XIf not indicated dierently, 
the left and right hearing
inruments can be 
inserted into either
charging slot. The slots
are not side specic.
XMake sure the bottom
parts of the hearing
inruments are placed 
well into the charging
slots.
Correct placement will be
indicated by the LED.
12
Charging atus
LED Status description
No LED light:
Charger is not connected to power supply.
No hearing inrument is inserted in the 
respective charging slot or the hearing
inrument is not inserted correctly.
Green LED light blinks 3 times:
Charger is connected to a power supply and
ready to charge.
Flashing green LED light:
Charging in progress.
13
LED Status description
Solid green LED light:
Hearing inrument is fully charged.
Red LED light blinks 3 times in 2 seconds: 
Error
Read more in section "Troubleshooting".
Charging tips
You may have some queions on how to be charge your 
hearing inruments. Read the queions and answers 
below. If you have more queions, your Hearing Care 
Professional will help you.
14
"
How often do I need to charge the hearing
inruments?
We recommend charging the hearing inruments daily, 
even if the power cell is not empty. Charge them overnight
so you can be sure to art your day with fully-charged 
hearing inruments.
"
How long does charging take?
A full charging cycle takes approximately 3 to 4 hours.
After 30 minutes, it is possible to use your hearing 
inruments for up to 7 hours.
Charging times may vary due to the use of the hearing
inruments and the age of the power cell.
15
"
Can I leave the hearing inruments in the charger?
Even when fully charged, you can leave the hearing
inruments in the charger. They automatically op charging 
when they are fully charged.
" What happens if I forgot to charge?
Your hearing inruments will automatically switch-o when 
the power cell is empty. Charge the hearing inruments as 
soon as possible.
Hearing inruments which have not been charged for over 
6 months may be damaged due to an unrecoverable deep-
discharge of the power cell. Deep‑discharged power cells
cannot be charged anymore and have to be replaced.
16
"
What if I intend not to use the hearing inruments
for several days or longer?
● Short-term orage (up to several days): Turn o your 
hearing inruments via the push button or place them in 
the powered charger.
The charger mu be connected to the power supply. 
If the charger is not connected to power supply and
you place your hearing inruments in the charger, the 
hearing inruments are not turned o.
Note that when you turn o the hearing inruments 
via a remote control or smartphone app, the hearing
inruments are not turned o completely. They are in 
andby-mode and ill draw some power.
17
● Long-term orage (weeks, months, ...): Fir, fully 
charge your hearing inruments. Turn them o via the 
push button before oring them. We recommend to use 
drying products while oring the hearing inruments.
At 6 month intervals you will have to charge the hearing 
inruments to avoid an unrecoverable deep-discharge 
of the power cell. Deep‑discharged power cells cannot
be charged anymore and they have to be replaced. We 
recommend recharging more frequently than 6 months 
intervals.
Observe the orage conditions in hearing inruments' 
user guide.
Ask your Hearing Care Professional for recommended
drying products.
18
"
What should I pay attention to when charging?
The hearing inruments and charger mu be clean 
and dry. Observe the operation conditions in section
"Operating, transport, and orage conditions". Avoid 
charging at high ambient temperatures, as this can shorten
the life span and capacity of the power cell.
If you use the charger in a very warm environment, note that
it will op charging in order to cool down if the charger's 
temperature exceeds 45 °C. The LED light will blink 3 
times in 2 seconds when this happens. Charging resumes
automatically after the device has cooled down. Do not
touch the hearing inruments, they may be hot. 
19
"
What should I pay attention to when using a power
rip with energy-saving features?
● Turn on the power rip before you insert the hearing
inruments in the charger. Otherwise, the hearing 
inruments may not be detected by the charger.
● Do not turn o the power rip while the hearing
inruments are in charger. Otherwise the hearing 
inruments will automatically turn on and discharge in 
the charger.
Before you turn o the power rip, remove the hearing 
inruments from the charger and turn them o via the 
push button.
20
Further information
Maintenance and care
NOTICE
Risk of injuries caused by electric shock!
XIf cleaning is required, disconnect the charger from
the power supply.
XClean the charger with a soft, dry tissue.
XNever use running water or immerse the charger in
water.
XDo not erilize or disinfect the charger.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44

Signia CHARGER BTE P User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI