Premier Mounts PSD-DPAB Installation guide

I've reviewed the Premier Mounts PSD-DPAB Installation Guide. This document outlines the necessary steps for mounting the base, including marking mounting holes, drilling, and securing the base using finned anchors, lag bolts and washers. I'm ready to answer your questions about the installation process.
What size drill bit is needed for installation?

What is the purpose of the finned anchors?

What size is the Allen key?

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100

1321 S. State College Blvd., Fullerton, CA 92831 USA

Installation Guide

PSD- DPAB

5/32” Allen KeyFinned Anchor5/16” Washers 5/16” x 3”

Lag bolts

Base

x1x4x4 x4x1

1 2

Find your desired mounting location. Use a pencil and mark 4

mounting holes locations through the slots.

Lightly hammer the finned anchors into the holes. Place the base over the finned anchors and use one

5/16” x 3” lag bolt and 5/16” washer per hole.

Use a drill gun and a 3/8” concrete drill bit on mark locations.

Finned Anchor

5/16” x 3”

Lag bolts

5/16” Washer

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100

1321 S. State College Blvd., Fullerton, CA 92831 USA

5 6

Installation Guide

PSD - DPAB

9500106_0

M8 x 10mm

Socket Set

Use 5/32” Allen Key to tighten the pre-installed M8 x 10mm

Socket Set screws.

5/32” Allen Key