Weil-McLain 80 Owner's manual

Category
Pellet stove
Type
Owner's manual

This manual is also suitable for

Part Number 550-141-936/0602
Beckett burners
Models CF500-W, CF800-W, CF1400-W and
CF2300A-W Flame retention type, for
light oil firing
Burner specifications and data
80Water & steam boilers
for use with Gas, Light Oil, &
Gas/Light Oil – Fired Burners
Model CF2300A-WModel CF1400-WModel CF800-WModel CF500-W
Beckett – CF500-W, CF800-W, CF1400-W and CF2300A-W
2Part Number 550-141-936/0602
Notes Burner capacities listed for elevations up to 2,000 feet. For higher elevations, consult
local Weil-McLain distributor/agent or sales office.
Oil ratings based on No. 2 fuel oil with heating value of 140,000 Btu per gallon.
Boiler-burner unit to be adjusted to achieve + 0.1 inches W.C. pressure at flue collar,
resulting in positive pressure in firebox as listed.
R8184G combustion safety control uses a cadmium sulfide cell flame detector to
monitor oil flame, provides intermittent direct spark ignition of oil flame and manual
lockout switch.
1
2
3
4
Burner Specification and Data Sheet
3
Part Number 550-141-936/0602
Notes All motors furnished with integral overload protection with manual reset.
CF500-W and CF800-W burners are furnished for on-off operation only. CF1400-W
and CF2300A-W burners are furnished with mechanical pressure atomizing oil control
system with on-off operation, low fire start, high fire run and two-position air control
as standard. Low-high-low fire operation can be obtained by addition of SPST tem-
perature or pressure controller.
Settings shown are for initial start-up. Final settings should be determined after
combustion readings.
120/60/1 control circuit is used for all burners.
5
6
7
8
Beckett – CF500-W, CF800-W, CF1400-W and CF2300A-W
4Part Number 550-141-936/0602
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Weil-McLain 80 Owner's manual

Category
Pellet stove
Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI