Rugged Ridge 18475.02 Installation guide

I have read the provided installation instructions for the Rugged Ridge Steering Stabilizer 18475.03. This document contains information on how to install the replacement steering stabilizer on Jeep Wrangler JK models, including the necessary steps and components. I’m ready to answer any questions you may have about the installation procedure or the product itself.
What is included in the package?

What should I do after the installation?

What should I pay attention to during the installation?

Installation Instruction:

1. Park vehicle on flat level ground and set the emergency brake.

2. Turn wheels to a straight forward position.

3. Remove factory steering stabilizer from the vehicle.

4. Install the supplied red boot over the new stabilizer cylinder.

5. Now install one poly bushing and steel sleeve at each end.

6. Install using factory hardware.

Note: Be sure to install so that the cylinder body is mounted to the axle side as shown in photo

below. If mounted the opposite way damage can occur to the stabilizer.

7. After installation be sure to cycle steering and check for adequate clearance. In most cases the

factory stabilizer bracket on the tie rod assembly will need to be rolled down slightly to allow for

adequate clearance. After adjusting check again for adequate clearance.

7. Re-tighten all bolts after the first 100 miles and periodically thereafter.

Jeep Wrangler JK

OEM Replacement Steering

Stabilizer

Part # 18475.03

WHITE STEERING DAMPER 1

STEEL SLEEVE 2

HOURGLASS BUSHING 2

BOOT 1

BOOT TIE 1

SHOCK DECAL 1

Part # Description Qty

Contents:

TECHNICAL ASSISTANCE: Contact Rugged Ridge™ at 770/614-6101 if you have remaining

questions about this product or its installation.

©Omix-Ada, Inc. 3.1.08. All Rights Reserved

SEAT BELTS SAVE LIVES. PLEASE WEAR YOUR SEAT BELT.

/

Other documents