CTA PAD-PARAWPCL Owner's manual

Brand: CTA

Model: PAD-PARAWPCL

Type: Owner's manual

CTA PAD-PARAWPCL is a secure digital floor stand with a password combination lock, designed to protect and display tablets in various commercial and public settings. Its slim profile and sturdy base provide stability, while the lock ensures the safety of the enclosed device. Cable routing options allow for neat and organized wire management, keeping the charging cables and data cords out of sight.

Premium Thin Profile Floor Stand w/

Digital Password Combination Security Enclosure

PAD-CHKWDC

INSTRUCTION - MANUAL

CONTENTS:

INSTALLATION:

1. Assembling floorstand base :

M5 Allen Key

3. Attaching enclosure to VESA plate :

1A. Align the base plate (B) with the thin VESA profile (A) and screw in

the allen screws (D) with the allen key (J) turning it clockwise until secure-

ly tightened.

3A. Align enclosure (C) holes to VESA plate (A) holes. Turn in Screws

M5 X6 (D) above using provide tool (J) while holding hex nut (E) From

behind with fingers. Shown Above.

M5 Nut

M5 x 10

2. Cable routing :

4. Setting up the foam adapters :

4A. Identify the double sided adhesives (G). Peel away the backing

on both sides. Adhesive four of them behind the foam pieces (I) as

illustrated. They are to adhese the foam to the enclosure. Peel away

the back on the next four and place them on top of the foam pieces

as illustrated. These are to attach the foam to the tablets and ensure

security.

D2C.Insert the cable through

the cutouts at floorstand head

and take it out in the cutout of

the back of the base.

2A. Plug one end of the tablet

cord into device, and route the

other end through hole in the

back as shown above.

2B. Cable route from enclosure

to the hole at the top of the body

as shown above.

888-733-4448

6A. When installing device into the enclosure, identify where the camera is.

Then simply remove and pop out the cover prior to mounting or setting up

tablet to properly expose camera.

6. Removing Enclosure Back Opening Covers :

7. Locking Enclosure :

7A. Once tablet is inserted, close the front cover securely.

7B. After, turn the digital lock 90º degrees clockwise.

This will lock the tablet in place.

**See following page

for digital lock usage

and setup

8A. Identify the lock chart port on the bottom side as illustrated. Plug in provided

charging cable (H) from one end to another to properly charge digital lock.

8. Charge the lock :

**Tablet shown for

illustration only,

NOT INCLUDED.

**Tablet shown for

illustration only,

NOT INCLUDED.

9A. Tilt up/down for preferred angles as needed. Rotate left and right for

preferred orientation.

9. Adjusting angles & orientation :

**Tablet shown for

illustration only,

NOT INCLUDED.

**Tablet shown for

illustration only,

NOT INCLUDED.

5. Inserting Tablet into Enclosure :

5A. With the enclosure open, insert tablet into the foam adapters (I). Make

sure the adhesives have been placed ahead of time or tablet will fall out.

Plug your tablet into any cables/wires you have routed to the enclosure.

After tablet is secure, close the top and lock into place.

888-733-4448

CTA PAD-PARAWPCL Owner's manual

CTA PAD-PARAWPCL Owner's manual

CTA PAD-PARAWPCL Owner's manual

Related papers

Other documents