Quick
Installation Guide
Airpho Technology Co.,Ltd
Web: www.airpho.com
Physical Connection
Note: For simplicity, we will take AR-FS105 for example throughout this guide
POWER ON/OFF LA N1 LA N2 L AN3 LA N4 DS L
Internet
Power
AR-FS105
Router
Printer
Laptop
Computer
For All Desktop Switch Models
For technical support and other information,
please visit: www.airpho.com.
AIRPHO is a registered trademark of AIRPHO Technology Co., Ltd.
Other brands and product names are trademarks or registered
trademarks of their respective holders.
Copyright ©2017 Airpho Corporation. All rights reserved.
Frequently Asked Questions (FAQ)
-Q1. The Power LED is not lit.
The Power LED should be lit when the power system is
working normally. If the Power LED is not lit, please
check as follows:
Make sure the power cord is connected to the switch A1:
with power source properly.
Make sure the voltage of the power supply meets the A2:
requirements of the input voltage of the switch.
Make sure the power source is ON.A3:
-Q2. The Link/Act LED is not lit when a device is
connected to the corresponding port.
It is recommended that you check the following items:
Make sure that the cable connectors are firmly A1:
plugged into the switch and the device.
Make sure the connected device is turned on and A2:
working well.
The cable must be less than 100 meters long (328 A3:
feet).
scan for more info
LED Indication
Link/Act
(Port 1-5/
8/16)
Off
Off
Solid
Power supply is provided for
the device properly.
Power supply is not provided
for the device properly.
Indicates the corresponding
port is connected but has no
data transfer.
Indicates the corresponding
port is connected and
transferring data.
Indicates the corresponding
port has no connection.
LED Status
Explanaction
Solid
Flashing
COPYRIGHT & TRADEMARKS
Marking with the above symbol indicates compliance with the essential
requirements and other relevant provisions of Directive 2014/30/EU
(EMC) ，Directive 2014/35/EU (LVD).
This is a class B product. Ina domestic environment, this product may
cause radio interference, in which case the user may be required to
make adequate measures.
CE Mark Warning
For simplicity, we use AR-FS105 for illustration here.
MADE IN CHINA
/