ProTemp PT-02-230 User's Manual And Operating Instructions

Category
Household fans
Type
User's Manual And Operating Instructions

This manual is also suitable for

Model #’s: PT-02-230, PT-033-230,
PT-033-230, PT-05-400, PT-09-400
Users Manual and
Operating Instructions
Electric Fan Heater
Do not operate this heater until you have read, and
thoroughly understand these safety and operating
instructions. Failure to comply with the precautions and
instructions provided with this heater can result in death,
serious bodily injury, property loss or damage from the
hazards of fire, explosion, burns, or electric shock. Only
persons who can read and understand these instructions
should use or service this heater. Not for recreational
vehicle use.
821000175-11
CONSUMER: Retain this manual for future reference.
Table of Contents
English ................................................................. 2-3
Spanish................................................................. 4-5
French ................................................................. 6-7
Dutch .................................................................. 8-9
Exploded View and Parts List............................ 10-11
copyrighted document - all rights reserved by FBC
Page 2 EN Electric Fan Heater User’s Manual
Introduction
Electric Fan Heater
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING, OR WHILE CONNECTED
TO A POWER SOURCE.
- At first turn the thermostat to “Max” and let the
heater operate with full power input. When the
room temperature reaches the required value, turn
the thermostat to the left until it switches off.
- The thermostat will then switch on and off auto-
matically to control the room temperature
according to the preset value and to keep the
room temperature constant.
- When using the heater for the first time, you may
notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating
element is made of steel and was coated with a
layer of protective oil during production. The
smoke is caused by the leftover oil as it is heated.
Technical Specifications
Specifications subject to change without notice
Thermostat Instructions
- The fan heater is not suitable for use outdoors in
damp weather, in bathrooms or in other wet or
damp environments.
- Please note that the fan heater can become very
hot and should, therefore, be placed at a safe
distance from flammable objects such as furniture,
curtains and similar objects.
- Do not cover the fan heater.
- Do not place the fan heater immediately under a
wall outlet.
- Do not connect the fan heater using an on/off timer
or other equipment which can automatically switch
the device on.
- The fan heater must not be placed in rooms where
flammable liquids or gases are used or stored.
- If an extension cable is used, it must be as short
as possible and must always be fully extended.
- Children should be supervised to ensure that they
do not play with the appliance. The appliance in
not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge.
If the appliance is damaged, do not use it any
more.
Special Safety Regulations
Model Voltage / Hz Power
Rating
Settings Temp Fuse
requirement
Dims Weight
PT-02-230 230V~50Hz 2,000
4 (OFF, 650W,
1300W, 2000W)
continuously
adjustable 0-85°C
10A
197x210x303
mm
4.2 kg
PT-033-230 230V~50Hz 3,300
4 (OFF, 30W, 1650W,
3300W)
continuously
adjustable 0-40°C
16A
250x250x390
mm
5.6 kg
PT-05-400 400V~50Hz 5,000
4 (OFF, FAN, 2500W,
5000W)
continuously
adjustable 0-40°C
10A
250x250x390
mm
6.6 kg
PT-09-400 400V~50Hz 9,000
4 (OFF, FAN, 4500W,
9000W)
continuously
adjustable 0-40°C
16A
350x440x480
mm
11.8 kg
To get the most out of your new fan heater, please
read through these instructions and the attached
safety regulations before use. Please also save the
instructions in case you need to remind yourself of
the fan heater’s functions at a later date.
- Housing of steel plate and heat-resistant lacquer
- Supplied complete with cable and plug
(9w may not include cable or plug).
Figure 1. Fan Heater Dials
Function Selector with
three power settings
Thermostat Dial
copyrighted document - all rights reserved by FBC
Special Safety Regulations (cont.)
- Do not place the appliance on moving vehicles or
somewhere it may easily tip over.
- Use the appliance in places with good air
ventilation, do not position it near a wall or corner.
- It is recommended that a separate circuit serving
only this appliance be provided. Keep the power
cable far enough from the hot air outlet.
- If the supply cable is damaged, it must be replaced
by the manufacturer or service agent or a similarly
qualified person in order to avoid a hazard.
- You must not connect other appliances to the
same electrical outlet as the fan heater.
- Do not dispose of electrical appliances as unsorted
municipal waste; use separate collection facilities.
Contact your local government for information
regarding the collection systems available. If
electrical appliances are disposed of in landfills or
dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging
your health and well-being. When replacing old
appliances with new ones, the retailer is legally
obligated to take back your old appliance for
disposals free of charge.
- If the fan heater is to be permanently installed, the
following instructions must be observed (see figure
2).
Operation
- Position the fan heater so that it stands upright on a
firm surface and at a safe distance from wet
environments and flammable objects.
- Connect the fan heater to the electrical power.
- Set the thermostat dial to the maximum
temperature.
- The fan heater will switch on when the function
selector dial is set to one of the three power
settings.
- Once the room reaches the desired temperature,
turn the thermostat dial back until heating element
turns off. The fan will still continue to run. The
thermostat is now set at your desired temperature,
and the heater will continue to maintain a constant
temperature.
Cleaning and Maintenance
- Before cleaning the appliance, disconnect it from
the outlet and let it cool down.
- The enclosure is easy to get dirty. Wipe it often
with a soft sponge. For very dirty parts, wipe with a
sponge dipped in < 50°C water and mild detergent,
then dry the heater enclosure with a clean cloth.
Be careful not to let the water enter the inside of
the appliance
- In order to protect the enclosure
, don’t splash
water onto the heater, and never use a solvent like
gasoline, isoamyl acetate, toluene, etc. to clean
the heater.
- Clean the coupler, dry and pack it in a plastic bag.
- When you store the heater, let it cool down first
and, keep it dry. Then cover it with a plastic bag,
put it in the packing box and store it in a dry,
ventilated place.
Electric Fan Heater User’s Manual EN Page 3
Figure 2. Installing your Heater
Electric Fan Heater
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING, OR WHILE CONNECTED
TO A POWER SOURCE.
copyrighted document - all rights reserved by FBC
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

ProTemp PT-02-230 User's Manual And Operating Instructions

Category
Household fans
Type
User's Manual And Operating Instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages