Shape Products, LLC | 1821 Indianhead Drive Menomonie, WI 54751
Phone: 715-232-0495 | Fax: 715-232-0580 | www.ShapeProducts.com
4438DAK & 5338DAK Adaptor Kit
Installation Instructions
Kit Components:
x10 x14
x10 x10
Top Panel x1
Side Panel x2
Step 1
While your window well cover is on the well, measure
how far below the top most point of the cover your siding
runs. Also measure how thick your siding is. These
dimensions will determine the cuts needed in the side
panels ( ). Mark this on the side panels and cut them
with a jigsaw (if available) or tin snips.
Step 2
Position and secure (tape works fine) each panel on
the window well cover. The top panel should be
centered with the longest edge against the siding.
Side panels should be against the house and flush
with the overhang of the top panel. Using a ¼” bit,
drill through the pre-drilled
holes and through the
window well cover.
Step 3
Side Panel (x2)
Adaptor Kit
Washer
Lock
Washer
Washer
(Top Panel
ONLY)
e number below and
CLEANING: Window Well Covers may be cleaned with a mild solution of detergent and water.
Use of harsh chemicals and scouring powders should be avoided.
If you have any questions or concerns, please feel free to give us a call at th
we will do our best to work with you.
Top Panel
Side Panel
Trim for Siding
below
Remove tape and clear any dirt debris from cover
and panels. Take protective film off of the panels.
Bolt the panels to the well cover according to the
diagram to the right. Do not over-tighten nuts as
this could crack the polycarbonate.
Products
Egress Dome
/
