StoveTop FireStop 675-127 User guide

Type
User guide
675-119
675-121, Rev -, 02-2016
STOVETOP FIRESTOP
RANGEHOOD/STFS PLUS
MAGNET MOUNTING KIT
INCLUDED IN THIS BAG
Magnet Assembly (x2)
[
Magnet with ring attached]
INCLUDED IN THIS BAG
© 2016. WilliamsRDM, Inc. All rights reserved. StoveTop FireStop and the StoveTop FireStop logo are
either registered trademarks or trademarks of WilliamsRDM in the United States and/or other countries.
Patent information at www.stfs.com/patents. 03-2016
675-121, Rev -, 02-2016
675-119
STOVETOP FIRESTOP
RANGEHOOD/STFS PLUS
MAGNET MOUNTING KIT
ACCESSORIES
ACCESSORIES
For more information and video demonstrations,
visit www.stfs.com
For more information and video demonstrations,
visit www.stfs.com
Magnet Assembly (x2)
[
Magnet with ring attached]
Insert the end of
the ring on the
magnet assembly (C)
through the hole in the
pin on top of canister
(B), and rotate one half
turn, like keys on a key
ring.
Lift canister (B)
straight up and
mount in the range
hood (A). Repeat with
second canister on
other side of cooktop.
Installation is
complete.
Remove foam
spacer, if present,
and discard.
Center each
canister (B)
between the front and
back burners, then lift
straight up into the
range hood (A). Mark
this spot, after making
sure it is free of grease,
clean, and dry.
*This kit will only work for StoveTop FireStop Venthood
products with the following characteristics:
• Has short post with a hole protruding from the top;
•The label contains the firefighter STFS logo, and a
yellow field;
• Purchased mid-2013 and before.
More translations available online at www.stfs.com/safety
Neglecting to follow these instructions could
negatively affect product performance.
Installation Instructions
Magnet Mounting Kit
for pre-2014 STFS Venthood
Firefighter in logo Yellow field
Post with hole
  • Page 1 1
  • Page 2 2

StoveTop FireStop 675-127 User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI