PowerSmith PWL2060TS User manual

PWL2042TS

4200 LUMEN

DUAL-HEAD LED WORK LIGHT WITH TRIPOD

Operator's Manual

SAVE THIS MANUAL FOR FUTURE REFERENCE

WARNING: To reduce the risk of injury, user must read and understand this

operator's manual before operating this tool.

888-552-8665

TOLL-FREE

HELP LINE:

WWW.POWERSMITHTOOLS.COM

2

English

IMPORTANT SAFETY INSTRUCTIONS

READ AND UNDERSTAND ALL WARNINGS, CAUTIONS AND OPERATING INSTRUCTIONS

BEFORE USING THIS EQUIPMENT. Failure to follow all instructions listed below may result in

electric shock, ﬁre and/or serious personal injury.

CAUTION: RISK OF ELECTRIC SHOCK, Do not use with extension cord near

water or where water may accumulate. Keep work light at least 16 feet from pools and spas.

Keep plugs and receptacles dry. Use only three wire outdoor extension cords with grounded

plugs and grounded receptacles.

WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR

PERSONAL INJURY

• Ground Fault Circuit Interrupter (GFCI) protection should be provided on the

circuit(s) or outlet(s) for this work light to be used at wet location. Receptacles are available having the built-in

GFCI protection and are able to be used for this measure of safety.

•Use only with an extension cord for outdoor use, such as an extension cord of cord type:

SW, SW-A, SOW, SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A, SJOW, SJOW-A, SJTW, SJTW-A, or SJTOW,

SJTOW-A.

•Do not look directly at the lighted lamps to avoid eye injuries.

•Always keep the work light away from any ﬂammable surface or materials.

•Always check damaged or worn-out parts before using the work light.

Broken

parts will affect the work light operation. Replace or repair damaged or worn parts immediately. If repairs are

needed, consult a professional electrician.

•Do not use a pressure washer to clean this product.

•Do not modify the work light in any way.

Unauthorized modiﬁcation may impair the function

and/or safety and could affect the life of the product. There are speciﬁc applications for which the work light was

designed.

•Store work light in a secure place out of the reach of children. Inspect it for good

working condition prior to storage and before re-use.

SAVE THESE INSTRUCTIONS

SPECIFICATIONS

•Model:--------------------PWL2042TS

•OutputPower:-------------2x20Watts

•RatedVoltage:-------------120V~,60Hz

•Brightness:----------------4200Lumens

•ColorTemperature:--------5000KBrightWhite

•CordLength:--------------9ft.

•TripodHeight:-------------48"

•NetWeight:--------------- 8.4lb

WorkLightHeads   2

StandwithCarryingHandle  1

Tripod    1

Operator'sManual  1

1. CarryingHandle

2. WorkLightHeads

3. Lenses

4. SideLockingKnobs

5. On/OffSwitches

6. PowerCord

7. Stand

8. Tripod

FIG 1

55

6

1

3

4

8

7

2

4

3

English

KNOWING YOUR WORK LIGHT

UNPACKING AND CONTENT

IMPORTANT! Due to modern mass production techniques, it is unlikely the product is

faulty or that a part is missing. If you ﬁnd anything wrong, do not operate the product until the

parts have been replaced or the fault has been rectiﬁed. Failure to do so could result in serious

personal injury.

CONTENTS IN PACKAGE

Description QTY Description QTY

FIG 3

D2

E2

E

E3

E1

B

F

A

C1

C2

D1

FIG 4

E3

E2

E1

FIG 2

7

1

H

G4

2

G3

G1

4

English

ASSEMBLY INSTRUCTION

ATTACHING WORK LIGHT

HEADS TO STAND (FIG 2)

1.Placethestand(7)onaatsurface.

2.Rotatethe carryinghandle(1)straight up.Tighten

the handle locking knob (G3) to secure it in place.

3.Usethelockingknobs(G1),atwashersandspring

washers to secure both work light heads to the sides

ofthestandasshowninFIG2.

4.Hangthepowercablesplitter(H)onthehook(G4).

ADJUSTING THE TRIPOD (FIG 3)

1.Loosenthetripodlockingknob(F).

2.Pushdownthelegconnector(A)untilthelegs(B)

are fully extended and ﬁrmly tighten the locking

knob (F).

3. Adjust the height of the tripod by loosening the twist

collars(C1&C2)andraisingthecenterpoles(D1&

D2)oftripod.Firmlytightenthetwistcollarswhen

the tripod reaches desired height.

NOTE:Themaximumheightofthistripodis48".

ATTACHING THE WORK LIGHT

ASSEMBLY TO THE TRIPOD

(FIG 4)

1.Placetheworklightassemblyontopofthetripod.

2.Use the bracket locking system (E1, E2 and E3)

to secure the work light assembly to the tripod as

showninFIG4.

NOTE:Makesurethetwolockingbrackets(E1)are

over the raised metal plate in the middle of the stand.

5

English

OPERATION

ADJUSTING THE LIGHT DIRECTION

Eachoftheworklightheadscanbetiltedverticallyupto30°downor90°up.

To Adjust the Light Direction,loosenthesidelockingknob(4-FIG1).Adjusttheworklightheadtothedesired

position, and retighten the knob.

ON/OFF SWITCH

EachoftheworklightheadsisequippedwithanON/OFFswitch(5-FIG1)locatedonthebacksideoftheworklight.

Presstheswitchoncetoturntheworklightonandpresstheswitchasecondtimetoturnitoff.Alwaysturnthework

light off before unplugging.

MAINTENANCE

Yourworklightrequiresverylittlecareandmaintenance.Simplycleanthelensregularlywithanon-abrasivecleaner.

Use the similar care for the stand and tripod.

WARNING: Always make sure the work light is unplugged and

completely cool before attempting to clean it.

WARRANTY

Thisproductiswarrantedfreefromdefectsinmaterialandworkmanshipfor2(Two)yearsafterdateofpurchase.This

limited warranty does not cover normal wear and tear or damage from neglect or accident. The original purchaser is

coveredbythiswarrantyanditisnottransferable.Priortoreturningyourtooltostorelocationofpurchase,pleasecall

Toll-FreeHelpLineforpossiblesolutions.

ACCESSORIES INCLUDED IN THIS KIT ARE NOT COVERED BY THE 2 YEAR WARRANTY.

HELP LINE

ForquestionsaboutthisoranyotherPowerSmith™ product,

PleasecallToll-Free: 888-552-8665.

Or visit our website: www.powersmithproducts.com

Richpower Industries, Inc.

736HamptonRoad

Williamston,SC29697

PrintedinChina,onrecycledpaper

Page is loading ...

Richpower Industries, Inc.

736HamptonRoad

Williamston, SC USA

www.richpowerinc.com

2018.08V01

PowerSmith PWL2060TS User manual

This manual is also suitable for

PowerSmith PWL2060TS User manual

in other languages

Related papers

Other documents