US Stove DV21N Installation guide

Page 1

TESTED &

LISTED BY

OMNI-TEST LABORATORIES, INC

REPORT NO.:

215-S-31-4

PORTLAND

OREGON, USA

US

C

MODELS

DV8 (N,L)

DV14 (N,L)

DV21 (N,L)

NEED HELP ?

DO NOT RETURN THIS PRODUCT TO THE

STORE WHERE YOU PURCHASED IT.

If you have questions about assembling or

operating this appliance or if it seems defective

or parts are missing or replacement parts

required:

Please contact our Customer Support

1-800-750-2723

Page 2

Heater ............................

Page 3

610 m

MDV8

MDV14

MDV21

The efficiency rating of the appliance is

a product thermal efficiency rating

determined under continuous operating

conditions and was determined

independently of any installed system.

or

/NG

Propane/

/NG

/NG /NG/LP /LP

Page 4

MDV8

MDV14

MDV21

12 15/64”

19 39/64”

25 19/32”

5 1/32” (MDV8-MDV14)

7 1/32” (MDV21)

24 5/64”

Do not use this appliance if any part has been under water. Immediately call a qualified technician to inspect

the appliance and to replace any part of the control system and any gas control which has been under water.

Page 5

* This installation information applies in the USA, for Canadian

installation refer to page 7 of this manual

*

(For U.S. vent terminal installations)

Page 6

4.

Clearance above grade, veranda,

porch, deck, or balcony

12 inches (30cm)

Clearance to window or door that may

be opened

6 inches (15 cm) for appliances <

10,000 Btuh (3 kW), 9 inches (23 cm)

for appliances > 10,000 Btuh (3 kW)

and < 50,000 Btuh (15 kW), 12 inches

(30 cm) for appliances > 50,000 Btuh

(15 kW).

Clearance to permanently closed

window

Vertical Clearance to ventilated soffit

located above the terminal within a

horizontal distance of 2 feet (61 cm)

from the center line of the terminal

Clearance to unventilated soffit

Clearance to outside corner.

Clearance to inside corner.

Clearance to each side of center line

extended above meter/regulator

assembly.

Clearance to service regulator vent

outlet.

Clearance to nonmechanical air supply

inlet to building or the combustion air

inlet to any building or other appliance.

6 inches (15 cm) for appliances <10,000

Btuh (3 kW), 9 inches (23 cm) for

appliances > 10,000 Btuh (3 kW) and <

50,000 Btuh (15 kW), 12 inches (30 cm)

for appliances > 50,000 Btuh

(15 kW).

Clearance to mechanical air supply

inlet.

Clearance above paved side walk or

paved driveway located on public

property.

Clearance under veranda, porch,

deck or balcony.

3 feet (91 cm) above if within 10 feet

(3 m) horizontally.

Canadian Installations¹

6 inches (15 cm) for appliances <

10,000 Btuh (3 kW), 12 inches (30

cm) for appliances > 10,000 Btuh

(3kW) and <100,000 Btuh (30kW), 36

inches (91 cm)for appliances >

100,000 Btuh (30kW).

3 feet (91 cm) within a height 15 feet

(4.57 m) above the meter/regulator

assembly.

6 inches (15 cm) for appliances < 10,000

Btuh (3 kW), 12 inches (30 cm) for

appliances > 10,000 Btuh (3kW) and

< 100,000 Btuh (30kW), 36 inches (91

cm) for appliances > 100,000 Btuh

(30kW).

6 feet (1.83 m)

7 feet (2.13m)

12 inches (30cm)

3 feet (91 cm)

12 inches (30cm)

2

Page 7

Page 8

A vent shall not terminate directly above a sidewalk or paved driveway that is located between two single family dwellings and serves both

dwellings.

Permitted only if veranda, porch, deck, or balcony is fully open on a minimum of two sides beneath the floor.

Page 9

MDV8

MDV14

MDV21

Do not connect this appliance to a chimney flue serving a separate

solid fuel appliance.

Page 10

7 1/4”” 1./4”

5/8”

6 1

./2””

1 3/8””

3 7/8””

3 1

./2””

MDV8

MDV14

MDV21

HEATER

8 1./2””

1 3/8”” 3/8”

4 7/8””

Page 11

Pilot Hole

Wall Bracket

Template

3-1/2”

FLOOR LINE

Marking for

Flue Outlet

Hole

Marking for Wall Bracket

Mounting Holes - 4 Qty.

Marking for

Gas Inlet

Hole

3-1/2”

FLOOR LINE

9

3-1/2”

Page 12

Holes

10

Page 13

10

Page 14

10

Gases Outlet

Cap

Attach the gases outlet cap making sure that the threaded rod comes

through the center hole in the cap. Secure the gases outlet cap by

attaching the washers and the brass blind nut to the threaded rod using

a screwdriver, tightening to stabilize the vent kit.

Page 15

Electrode

Wires

Front

of Unit

Back

of Cabinet

heater

Page 16

Page 17

Page 18

Call our customer service at 1 800 750 2723.

Page 19

Call our customer service.

Page 20

Page is loading ...

US Stove DV21N Installation guide

This manual is also suitable for

US Stove DV21N Installation guide

Related papers

Other documents