Miller GAS CYLINDER RACK/MIXED GAS REGULATOR Owner's manual

Type
Owner's manual

This manual is also suitable for

OWNER’S MANUAL
FORM: OM-230806A 200711
Use above FORM number when ordering extra manuals.
Gas Cylinder Rack/Mixed Gas Regulator 300237 for Renegadet 180
NOTICE Lift Eye Kit 195353 CAN NOT be installed when this kit is installed.
1. Safety Symbol Definitions
DANGER! Indicates a hazardous situation which, if not
avoided, will result in death or serious injury. The possible
hazards are shown in the adjoining symbols or explained
in the text.
Build-up of gas can injure or kill. Shut off shielding gas
supply when not in use. Always ventilate confined spaces
or use approved air-supplied respirator.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury. The possible ha-
zards are shown in the adjoining symbols or explained in
the text.
Falling equipment can cause serious personal injury and
equipment damage. Do not lift unit with cylinder
installed on rack. Lift and support only with proper
equipment and correct procedures.
NOTICE
Indicates statements not related to personal injury.
Indicates special instructions.
Tipping equipment can cause injury and damage
equipment. Do not move cart where two wheels are at
different heights and cart could tip avoid tipping. Be
careful when moving unit over uneven surfaces. Do not
use an oversized cylinder or exceed maximum cylinder
weight.
Wear safety glasses with side shields. Cylinders contain gas under high pressure and can ex-
plode if damaged. Never let a welding electrode touch
any cylinder. Always secure cylinder to running gear, wall,
or other stationary support.
Beware of electric shock from wiring. Stop engine and
disconnect negative () cable from battery before install-
ing this kit. Reinstall all panels and covers.
2. Parts List
Description
Part
No.
300237
Item
No.
Gas Cylinder Rack/Regulator
Quantity
1 229713 Bracket, Mtg Gas Bottle Lower 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2 229714 Bracket, Mtg Gas Bottle Side 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 229715 Bracket, Mtg Gas Bottle Upper 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4 230765 Strap, Retaining Cylinder Gas 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5 601941 Screw, 25020x1.75 Hexwhd.61d Gr5 Pld 5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6 152461 Nut, 25020 .44hex .23h Stl Pld Sem Cone Wshr.65d 5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7 602154 Screw, 25020x .50 Hexwhd.50d Stl Pld Slffmg Taprw 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8 221037 Regulator/Flowmeter, 1050 Cfh Argon/CO2 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9 229566 Hose, Gas 7 Ft 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
10 223861 Clip, Edge W/Cable Tie 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
11 230796 Label, Warning Oversized Cyl/Falling Eq 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
12 230797 Label, Warning Oversized Cyl/Falling Eq (Sp) 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
13 113786 Welding Wire, Stl Hard .030 4” Spool 2lbs ER70S61. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BE SURE TO PROVIDE MODEL AND SERIAL NUMBER WHEN ORDERING REPLACEMENT PARTS.
OM-230 806 Page 2
3. Installing Cylinder Rack And Gas Hose
804 723-B
Tools Needed:
Stop engine and let cool or discon-
nect utility input power.
1 Warning Label
2 Lower Gas Bottle Mounting Bracket
Apply one warning label to each side of the
mounting bracket.
3 1/420 x 1.75 in. Screw
4 1/420 Nut
5 Upper Gas Bottle Mounting Bracket
Install lower mounting bracket using sup-
plied 1/420 hardware. If using gas cylin-
ders with a safety strap height greater than
24 in. (610 mm), install upper gas bottle
mounting bracket using supplied 1/4-20
hardware.
6 Side Gas Bottle Mounting Bracket
7 1/420 x .5 in Screw
If using gas cylinders with a safety strap
height less than 24 in. (610 mm), install
side mounting bracket using supplied
1/420 screws.
1
2
3
5
4
6
3
7
Maximum Cylinder Weight = 80 lb (36.3 kg)
Maximum Cylinder Diameter = 7 in. (178 mm)
Maximum Cylinder Height = 48 in. (1220 mm)
OM-230 806 Page 3
804 968-A
Tools Needed:
Stop engine and let cool or discon-
nect utility power.
1 Gas Hose
2 Side Frame Bracket
3 Edge Clip
Remove strap from clip, turn 90 degrees
and insert into clip as shown. Push clips
onto lower edge of frame side frame brack-
et.
Route gas hose from rear of unit to front.
Connect gas hose to front panel. Secure
gas hose with edge clip straps.
1
2
3
OM-230 806 Page 4
4. Installing Gas Supply
! Tipping equipment can
cause injury and damage. Do
not exceed maximum cylin-
der weight, diameter, and/or
height for this cylinder rack.
1 Strap
Obtain gas cylinder and use strap
to secure to cylinder rack so
cylinder cannot fall and break off
valve.
2 Cap
3 Cylinder Valve
Remove cap, stand to side of valve,
and open valve slightly. Gas flow
blows dust and dirt from valve.
Close valve.
4 Cylinder
5 Regulator/Flowmeter
Install so face is vertical.
6 Regulator/Flowmeter Gas
Hose Connection
7 Welding Power Source Gas
Hose Connection
Connect supplied gas hose to
regulator/flowmeter gas hose con-
nection.
8 Flow Adjust
Typical flow rate is 20 cfh (cubic
feet per hour). Check wire
manufacturer’s recommended flow
rate.
Tools Needed:
Ref. 802 028 / 804 968-A
5/8, 1-1/8 in
7
2
3
4
Argon Gas Or
Mixed Gas
5
6
8
. DO NOT use Argon/Mixed gas reg-
ulator/flowmeter with CO
2
shielding
gas.
1
. Shown for securing gas cylinders
taller than 24 in. (610 mm).
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Miller GAS CYLINDER RACK/MIXED GAS REGULATOR Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI