monitoring

2

For the projector to display the image, a function called Lens monitoring will have to be disabled in the projector.

You have 3 adjustment options available for this purpose:

1. Enter the Service Menu under Settings/Service and enter code 47838. Make sure Lens monitor is not ticked off.

2. Go via RS232 and enter the code: LMON0

3. Use dedicated application, GP3 Lensmonitoring to deactivate lens monitor. This program can be found on

Barco web site, technical downloads folder within the projector web page.

3

introduction

1

The EN33 projection lens does not incorporate the capability of the projector to detect that the lens is inserted.

As a result of that, the projector will not open the shutter when the lens is inserted.

4

notice

When Lens monitoring is disabled, the shutter will remain open regardless of whether a lens is inserted or not.

WARNING!

Do not look into the lens opening on the projector when the lens is not inserted and the projector is

powered on. The light coming out from the lens opening will be very bright!