Unbranded 58679 Installation guide

Post Cap

Care and Handling

Post Caps

To attach each post cap style to the post, ap-

ply an exterior-grade construction adhesive

to the underside of the post cap and place

ﬁrmly on the post (see Figure 1).

Important: All solar post caps and lights

will need 24 hours of direct sunlight

to fully charge.

Solar Post Caps

To activate your new solar post cap:

1

Remove top by pressing inward on the side

of the clear lens, grasping the edge of the

top and lifting it off (see Figure 2).

2

Install the batteries.

3 Replace top by snapping onto side panels.

(Ensure the holes in the sides are matched

up with the stubs on the top.)

4

Your solar post cap light is now ready to be

attached to your post (see Figure 1).

Some solar post caps have on/off switches. If your cap includes an

on/off switch, make certain it’s in the “on” position when you plan

to illuminate your lights. Batteries are included with solar post caps

but may not be installed. Ensure batteries are seated ﬁrmly in place

when installed.

Solar Tiffany-style Post Caps

To activate your new Solar Tiffany-style Post Cap:

1

Remove the solar panel by lifting it straight up

from the top of the cap (see Figure 3).

2

Install the batteries.

3 Replace the solar panel.

4 Your Solar Tiffany-style post cap is now ready

to be attached to your post (see Figure 1).

Post and Stair Lights

1

Slide plastic lens back to separate from

top portion.

2

Open battery compartment.

3 Remove the plastic tab from the battery compartment to allow

connection to the terminal.

4

Ensure battery is ﬁrmly in place and switch is in “on” position.

5 Attach bracket to post using screws included in package.

6 Slide the Post and Stair Light onto the bracket.

PRESS TO

REMOVE

TOP

Solar

Panel

Figure 1

Figure 3

Figure 2

2

3

Thank you for your purchase. The following pages contain information

to help you install and maintain your post caps for years of enjoyment.

Installation Instructions

If your post cap is not listed here, please check for installation instructions

inserted in or printed on the package.

day, our LED light bulbs will have an average life of 10 years. The

rechargeable batteries will last an average of one year. They must

be replaced with rechargeable batteries – using regular batteries in

the sun will destroy the solar collector in the post cap.

Please note that our LED light bulbs are part of the whole solar cell

component and are not designed to be replaced. If it is necessary to

replace your light bulb or your solar collector, we have Solar Collec-

tor Replacement Units available.

Contains nickel-cadmium rechargeable batteries. Battery must be

recycled or disposed of properly.

Post Cap Care and Maintenance

Metal Post Caps

Our copper, stainless steel, and brass post caps come with a thin,

clear marine lacquer designed to protect them before and during in-

stallation. Once exposed to the elements, the sun’s ultraviolet rays,

moisture and pollution begin to break down this coating, exposing

the metal underneath.

Solar Post Caps

Our Solar Metal Post Caps and Solar Tiffany-style Glass Post Caps

are among the unique, yet classic touches you can add to your outdoor

project. By day, they add beauty to your deck. By night, they enhance

your setting with a welcoming glow, without the hassles of wiring

or electricity.

By installing a solar post cap light on your deck, you are contrib-

uting to a greener environment. Solar post caps get their energy

from the sun, the Earth’s most available energy source. This helps

offset greenhouse gases and reduces the need for dry-cell battery

disposal. They are also economical – keeping your deck illuminated

with solar post caps will not increase your electric bill.

Looking for a softer glow? No need to illuminate all of your post caps.

Batteries can be taken out of the post cap, or the tab can be reinserted

into the battery compartment, to keep the light inactive. Keep in mind

that batteries will need to be allowed to recharge when reinserted.

Some post caps have on/off switches. Make sure the switch is in

the “off” position if you don’t want a particular cap to illuminate.

Included with each of our solar post caps are LED light bulbs and

rechargeable batteries. With a normal usage of 6 to 8 hours per

4

5

Copper

In its natural state, copper breaks down in the elements and develops

a patina. In general, copper progresses from a natural salmon color

to a series of russet browns and grays, and ﬁnally to a blue-green

or gray-green patina.

•Tomaintaintheshinylook,applyacarwaximmediatelyafter

purchasing the cap, and reapply every 3 to 6 months.

•To remove an already tarnished nish, remove the old coating

w

ith mineral spirits and grade 0000 steel wool. Buff with grade

0000 steel wool for a satin ﬁnish. For a mirror-like ﬁnish, apply a

car

w

ax

o

r

s

pray

w

ith

a



c

lear

l

acquer

o

r

p

olyurethane

a

nd

l

et

d

ry,



andthenapplyacarwax.

•To

e

ncourage

a



n

atural

p

atina,

r

emove

t

he

l

acquer

w

ith

m

ineral



spirits and grade 0000 steel wool.

Stainless Steel and Brass

Stainless

s

teel

h

as

a



h

ard

o

xide

c

oating

m

aking

i

t

r

esistant

t

o



stains.Tomaintainthiscoating,cleanperiodicallywithamixtureof

v

inegar and club soda. As with the copper, our brass post caps are

protectedwithathin,clearcoatingoflacquer.Periodicreapplica-

tion of this clear coating will help to protect the brass.

Colored Metal Post Caps

Our metal post caps come in a variety of colors, including white,

green,realpatina,pewterandblack. These colorsare apowder-

coated,

b

aked-on



nish

t

hat

i

s

e

xtremely

h

ard

a

nd

d

urable,

r

arely



requiringmaintenance.

Wood Post Caps

As with all wood products, we recommend that you coat these with

ahigh-qualityexteriornishtopreservethewood’snaturalbeauty

a

nd ensure a lifetime of enjoyment. Apply to all wood areas, includ-

ing the underside of the cap, before installation.

Glass Post Caps

Exposure



to



the



elements



may



cause



the



copper-wrapped



solder



on



yourglasspostcaptooxidizeandloseitsoriginalcolor.Applying

car

w

ax

b

efore

p

lacing

t

he

p

ost

c

ap

o

utdoors

w

ill

h

elp

t

o

p

revent

t

he



initialoxidation.Reapplythecarwaxevery3to6monthsasneeded.

Note: If your post cap has a wood base, apply a high quality exterior ﬁnish to

all wood areas before installation. We recommend reapplying the ﬁnish

annually to preserve the wood’s natural beauty and protect it from

the elements.

6

7

Page is loading ...

6611 5/11

Unbranded 58679 Installation guide

Unbranded 58679 Installation guide

in other languages

Related papers

Other documents