Connecting To an SC Network
To connect to an SC network, you need the following:
•
Patch cord for connecting the MT-RJ transceiver to the SC adapter
•
Adapter for connecting an SC cord to an SC network
1. Remove any cable protectors attached to the patch cord and adapter.
2. Connect the access point to your network as shown in the next illustrations.
SC connector
To access
point
SC connector
To SC
networ
k
SC adapter
FOI005.eps
FOI002.eps
SC connector
To
access
point
To
SC networ
k
To
SC network
SC adapter
SC connector
Connecting To an ST Network
To connect to an ST network, you need the following:
•
Patch cord for connecting the MT-RJ transceiver to the ST adapter
•
Adapter for connecting an ST cord to an ST network
1. Remove any cable protectors attached to the patch cord and adapter.
2. Connect the access point to your network as shown in the next illustration.
FOI001.eps
ST connector
ST adapter
ST connector
To
access
point
To
ST network
To
ST network
Enabling Fiber Optic
After you have connected the access point to your fiber optic network, you must
enable fiber optic on the access point.
1. Point your Web browser to your access point’s IP address. The access point
Web interface opens.
2. Click Ethernet from the AP Configuration menu. The Ethernet screen appears.
3. Click Port Type and choose 100 Mb Fiber Optic.
4. Click Submit Changes and follow the instructions that appear on your screen.
5. You must reboot the access point to enable your changes. Click Save/Discard
changes and follow the instructions that appear on your screen to reboot the
access point.
*072226-001*
*072226-001*
6001 36th Avenue West
P.O. Box 4280
Everett, WA 98203-9280
© 2001 Intermec Technologies Corp.
All Rights Reserved
Connecting Fiber Optic Access Points
To connect your fiber optic 2100 or 2101 access point to your network, you
must have a patch cord and an adapter. Patch cords and adapters are available
from many different manufacturers. Contact your Intermec representative for
help choosing the proper cord and adapter.
Using adapters and patch cords, you can connect your MT-RJ access point to
•
an MT-RJ network.
•
a square connector (SC) network.
•
a straight tip (ST) network.
Note: All cables must be multimode, 62.5/125 µm.
Connecting To an MT-RJ Network
To connect to an MT-RJ network, you need the following:
•
Patch cord for connecting the MT-RJ transceiver to the MT-RJ adapter
•
Adapter for connecting an MT-RJ cord to an MT-RJ network
1. Remove any cable protectors attached to the patch cord and adapter.
2. Connect the access point to your network as shown in the next illustration.
FOI006.eps
MT-RJ connector
To
access
point
MT-RJ adapter
To
MT-RJ
networ
k
-
1
-
2
Intermec MobileLAN access 2101 Connecting
- Type
- Connecting
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
HP ProCurve Series User manual
-
-
-
HP 2610 User manual
-
-
H3C S7503E Installation guide
-
-
Belden 1700ENH.00U305 Datasheet
-
-
WW WOHLER iAM-MIX16 User manual
