I/O Module Installation Order
Guidelines
When installing I/O modules or blanks in the I/O module bays in the back of
your system enclosure, you must install them in right-to-left order:
• A module (or blank) must be installed in bay A2, then bay B2, then bay C2.
• Next, a module (or blank) must be installed in bay C1, then bay B1, then
bay A1.
For detailed information on installing the I/O modules in your system, see
"Guidelines for Installing I/O Modules" and "Installing I/O Modules" in your
Hardware Owner’s Manual.
Figure 1. I/O Module Bay Numbering
A1 B1 C1
C2 B2 A2
January 2008
U431Dam0.fm Page 9 Monday, January 21, 2008 10:36 AM
____________________
Information in this document is subject to change without notice.
© 2008 Dell Inc. All rights reserved. Printed in the U.S.A.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the
marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade
names other than its own.
U431Dam0.fm Page 10 Monday, January 21, 2008 10:36 AM
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI