Seymour Duncan PowerStage 170 User guide

Hello! I am an AI chatbot trained to assist you with the Seymour Duncan PowerStage 170 User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

PowerStage 170 Quick Start Guide

Use a high quality speaker cable [2] to connect your PowerStage 170’s Speaker Output jack

to the input of a 4 - 16 ohm cabinet [4]. Using the supplied power cable [3], connect the

PowerStage 170 to a power outlet.

You can plug your guitar directly into the Input Jack [1], or plug into your favorite pedals and

run them into the Input Jack. The diagram above shows an example using the Seymour Duncan

805 Overdrive, Palladium Gain Stage and Andromeda Dynamic Delay.

At this point you are ready to power up the PowerStage 170. Make sure the volume control is

set all the way off before flipping the power switch. If this is the first time you are using the

PowerStage we recommend setting the EQ controls at noon and adjusting to taste from there.