2. Koala Kare
  3. 311-KIT

Koala Kare 311-KIT Operating instructions

  • I have reviewed the provided instructions for the KB115 Infant Seat Kradle strap replacement. The document outlines the steps for removing an old strap and installing a new one, including cutting, threading, and snapping components. The information includes step-by-step guidance with diagrams. I am ready to assist with any questions you might have about the instructions or the replacement process of the strap.
  • What tool is needed for this replacement?
    What should be done with the old strap?
    What should be done with the non-removable strap ring?
    How do I know that replacement strap is properly installed?
®®
KB115 Infant Seat Kradle
Koala Kare Products A Division of Bobrick
6982 South Quentin St., Centennial, CO 80112-3945
Main 303.539.8300 Toll Free 888.733.3456
Fax 303.539.8399
Koalabear.com
Replacement
Strap Instructions
Tools Required:
Scissors
P/N 312 - May 2017
P/N 311-KIT
1. Locate the end of the strap where the
ISKM legs cross. Using a pair of scissors, cut
through the loop and remove the entire strap
from the unit (Fig. 1) by un-threading it from
the strap holder on the mesh.
NOTE: The non-removable strap ring (Fig. 2)
must stay in place.
2. Insert end of replacement strap through
strap ring with buttons facing outward (Fig.
3). Snap together and test that all snaps
are engaged by pulling on the strap at the
buckle (Fig. 4).
3. Repeat on other side.
4. Feed buckle end of straps through the strap
loops on the mesh.
5. Feed buckle end of straps through the strap
loops on the mesh.
2
1
3
4
/