2. FLEXCO
  3. C/EBC Cutter

FLEXCO C/EBC Cutter Operating instructions

  • I have reviewed the user manual for modifying the Cutter EBC1 with a rail/guide system. The document provides detailed steps, including safety instructions, for attaching the retrofit kit. I'm ready to assist with any questions you may have regarding this process or the device itself.
  • What should I do before working on the cutter?
    What tools are required to loosen the rail lock nuts?
    What should I remove first?
How To Modify Your C/EBC Cutter
With The Rail/Guide System
Existing EBC1 shown with retrot rail kit.
Step 1. Loosen existing rail lock nuts with 8 mm or 5/16” hex and 17 mm box end/crescent wrench. Set aside lock nuts, bearings and washers.
NOTE: Be sure to unplug tool prior to working on it.
Stay clear of any sharp areas or pinch points.
Step 2. Attach retrot rail kit to existing structure as shown.
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 U.S.A.
Telephone: 1-630-971-0150 • Fax: 1-630-971-1180 • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2015 Flexible Steel Lacing Company. 04-22-20. For Reorder: X3963
Completed Tool
Step 3. (A) Remove bolt, washer, and lock nut
from new retrot rail kit.
(B) Add washer, bearing, and lock nut to
back of rail system.
(C) Add washer and lock nut to front, center of
railsystem.
(D) Add bolt, bearing, washer, and lock nut to front,
outside of rail system.
Step 4. Securely hand tighten all bolts and lock nuts.
A
B
C
D
/