2. PXM
  3. PX313

PXM PX313 User manual

  • I've reviewed the user manual for the PXM PX313 USB to RS485 converter, which is designed for upgrading devices without direct USB or LAN ports. The manual details the necessary steps for updating device firmware using an FTDI cable and the PxFlasher software. I'm here to help answer any questions you might have about the provided information or the device itself.
  • What is the purpose of this device?
    What software is needed for the upgrade?
    What cable is required for the upgrade?
PX313
USB/RS485
Interface
User manual
Table of Contents
1 Description...................................................................................................3
2 PXM device update manual using FTDI cable......................................3
3 Connection scheme...................................................................................4
Manufacturer reserves the right to make modications in order to improve device
operation.
PXM Marek Żupnik sp.k.
Podłęże 654
32-003 Podłęże
BDO register number 000005972
tel. +48 12 385 83 06
mail: [email protected]
www.pxm.pl
Rev.1-2
30.10.2019
2
1 Description
USB to RS485 converter for upgrading devices without USB or LAN
connector.
PxFlasher software is provided with the device, available to download
from manufacturer’s page (https://pxm.pl/).
2 PXM device update manual using FTDI
cable
1. Download the device update ?le (*.upg) from the manufacturer’s
website.
2. From the FTDI Chip website, download the drivers for the FTDI cable
(https://www.ftdichip.com/Drivers/VCP.htm), and then install them.
3. After installing the drivers for the FTDI cable, connect the cable to the
PC and to the device according to the diagram in section 3 Connection
scheme.
4. When the device is connected to the PC, the PxFlasher program can be
started.
5. In the running program, select “Connect” and select “USB-RS485 Cable”
from the drop-down list and click “OK”.
6. A window will appear with a progress bar, during this time power up
the device to be updated.
3
7. In a new window, information about the connected device will appear
and a question whether you want to update the ?rmware. To continue,
select “Yes”.
8. Browse to the update ?le on your computer (*.upg).
9. After the update is ?nished, a window will appear asking if you want to
start the device, selecting “Yes” the device will go to normal operation
mode.
3 Connection scheme
4
/