Transmitter DOLXFD1000BM Owner's manual

Brand: Transmitter

Model: DOLXFD1000BM

Category: Numeric keypads

Type: Owner's manual

This manual is also suitable for

DOLXFD1000BS

DOLXFD1000B-M/S

Mullion or Single Gang Keypad

with Card Reader

-40°+140°

IP66

V.1.19.18

PH 866.975.0101

FX 866.975.0404

www.transmittersolutions.com

The DOLXFD1000BS/DOLXFD1000BM is a single door mulifunction stand alone

access controller or a Wiegand output reader. It uses Atmel MCU assuring stable

performance. The operation is very user-friendly, and low-power circuit makes a

long service life.

The DOLXFD1000BS/DOLXFD1000BM supports 1,000 users (998 common users

+ 2 panic users), all user data can be transferred from one to another. It supports

multi access modes in either card access, PIN access, Card + PIN access, or multi

cards/PINs access. It has extra features including block enrollment, interlocked,

Wiegand26~37 bits interface...etc.

DOLXFD1000BMDOLXFD1000BS

DOLXFD1000BS DOLXFD1000BM

Notes: the DOLXFD1000BS/DOLXFD1000BM has 3 working modes: Stand alo

Mode, Controller Mode, Wiegand Reader Mode, choose the mode you would like

to use. (Factory default is Stand alone Mode / Controller Mode.)

The DOLXFD1000BS/DOLXFD1000BM can be worked as Stand alone Reader for

a single door. (Factory default mode)--7 2 #

DOLXFD1000BS/DOLXFD1000BM

For Multi cards/PINs access mode, the interval time of reading cards/inputting PINs

can not exceed 5 seconds, or else, the DOLXFD1000BS/DOLXFD1000BM will exit

to standby automatically.

The DOLXFD1000BS/DOLXFD1000BM can be work as a Controller, connected

with the external Wiegand reader. (Factory default mode)--7 2 #

The DOLXFD1000BS/DOLXFD1000BM connected with External Card Reader:

- If EM card reader of HID card reader: users can be added/deleted on either the

DOLXFD1000BS/DOLXFD1000BM or external reader.

- If Mifare reader: users can only be added/deleted on external reader.

DOLXFD1000BS/DOLXFD1000BM

The DOLXFD1000BS/DOLXFD1000BM connected with Fingerprint Reader:

For example:

Connect F2 as the fingerprint reader to the DOLXFD1000BS/DOLXFD1000BM,

it is of two steps to enroll the valid fingerprint.

Step 1: Add the Fingerprint (A) on F2

Step 2: Add the same Fingerprint (A) on the DOLXFD1000BS/DOLXFD1000BM

The DOLXFD1000BS/DOLXFD1000BM connected with Keypad Reader:

The keypad reader can be 4 Bits, 8 Bits (ASCll), or 10 Bits output format.

Choose the below operation according to the PIN output format of your reader.

> Add PIN Users:

To add PIN users, after enter into programming mode on the DOLXFD1000BS/

DOLXFD1000BM, PIN(s) can be input/ added on either the DOLXFD1000BS/

DOLXFD1000BM controller or the external Keypad Reader.

To DOLXFD1000BS/DOLXFD1000BM can work as Stanard Wiegand Reader,

connected to the third party Controller--- 7 3 #

Notes:

The EM version reads EM cards only, while the HID & EM version can be set to

read HID & EM cards, or HID card only, or EM card only. Factory default card type

of the HID & EM version is HID & EM cards, if you want to change the type, please

se the DOLXFD1000BS/DOLXFD1000BM to Stand Alone Mode (7 2 #) and then set

the type. (See page 11 for setting card type.)

DOLXFD1000BS/DOLXFD1000BM

User Information Transfer:

The DOLXFD1000BS/DOLXFD1000BM supports the Use Information Transfer

function, and the enrolled user (cards, PINs) can be transferred from one (let’s name

it master unit) to another (let’s name it accept unit)

DOLXFD1000BS/DOLXFD1000BM DOLXFD1000BS/DOLXFD1000BM

Interlock:

The DOLXFD1000BS/DOLXFD1000BM supports the Interlock function. It is two

keypads for two doors, and mainly used for banks, prisons and other places where

a higher level secuirty is required.

DOLXFD1000BS/DOLXFD1000BM DOLXFD1000BS/DOLXFD1000BM

TRANSMITTER SOLUTIONS WARRANTY

The warranty period of Transmitter Solutions keypad is twenty-four (24) months.

This warranty shall begin on the date the keypad is manufactured. During the

warranty period, the product will be,repaired or replaced (at the sole discretion

of Transmitter Solutions) if the product does not operate correctly due to a

defective component. This warranty does not extend to (a) the keypad case,

which can be damaged by conditions outside the control of Transmitter Solu-

tions, or (b) battery life of the keypad. This warranty is further limited by the

following disclaimer of warranty and liability:

EXCEPT AS SET FORTH ABOVE, TRANSMITTER SOLUTIONS MAKES NO WARRANTIES

REGARDING THE GOODS, EXPRESS OR IMPLIED, INCLUDING WARRANTY OF

MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. BUYER

MAKES NO RELIANCE ON ANY REPRESENTATION OF TRANSMITTER SOLUTIONS,

EXPRESS OR IMPLIED, WITH REGARD TO THE GOODS AND ACCEPTS THEM

“AS-IS/WHERE-IS”. TRANSMITTER SOLUTIONS SELLS THE GOODS TO BUYER ON

CONDITION THAT TRANSMITTER SOLUTIONS WILL HAVE NO LIABILITY OF ANY KIND

AS A RESULT OF THE SALE. BUYER AGREES THAT TRANSMITTER SOLUTIONS SHALL

HAVE NO LIABILITY FOR DAMAGES OF ANY KIND, WHETHER DIRECT, INCIDENTAL OR

CONSEQUENTIAL DAMAGES, INCLUDING INJURIES TO PERSONS OR PROPERTY, TO

BUYER, ITS EMPLOYEES OR AGENTS, AS A RESULT OF THE SALE. BUYER ALSO

AGREES TO HOLD TRANSMITTER SOLUTIONS HARMLESS FROM ANY CLAIMS BUYER,

OR ANY THIRD PARTY, MAY HAVE AS A RESULT OF BUYER’S USE OR DISPOSAL OF

THE GOODS. BUYER HAS READ THIS DISCLAIMER AND AGREES WITH ITS

TERMS IN CONSIDERATION OF RECEIVING THE GOODS.

2480 South 3850 West, Suite B

Salt Lake City, UT 84120

(866) 975-0101 • (866) 975-0404 fax

www.transmittersolutions.com

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20

Transmitter DOLXFD1000BM Owner's manual

Brand: Transmitter

Model: DOLXFD1000BM

Category: Numeric keypads

Type: Owner's manual

This manual is also suitable for

DOLXFD1000BS

Download PDF

Related papers

Other documents