Western 500 & 1000 Point of Purchase Display Stand #95631 Installation guide

Type
Installation guide
2
1
3
Model 500/1000 Point of Purchase Display Stand Parts List 95631
Copyright © 2004 Douglas Dynamics, L.L.C. All rights reserved. This material may not be reproduced or copied, in whole or in part, in any
printed, mechanical, electronic, film or other distribution and storage media, without the written consent of the company. Authorization to
photocopy items for internal or personal use by the company’s outlets or spreader owner is granted.
The company reserves the right under its product improvement policy to change construction or design details and furnish equipment when so
altered without reference to illustrations or specifications used. Do not exceed vehicle ratings with a spreader. The company offers a limited
warranty for all spreaders. See separately printed page for this important information.
Printed in U.S.A.
Lit. No. 95640 November 1, 2004
CAUTION
Read instructions before performing
modifications. Use standard methods and
practices when working on spreader including
proper personal protective safety equipment.
INSTALLATION INSTRUCTIONS
1. Insert control mount into receiver section, and
secure with two 3/8"-16 set screws.
2. Mount control brackets (not supplied) on the
control mount using the predrilled holes.
3. Insert spreader into receiver section, and secure
with hitch pin (not supplied) and ratchet straps.
95631
Model 500/1000 Point of Purchase Display Stand
Item Part Qty Description
1 95632 1 Base, Model 500/1000 Display Stand
2 95636 1 Control Mount, Model 500/1000
Display Stand
ns 95639 1 Parts Bag, Model 500/1000 Display
Stand
95639 Parts Bag, Model 500/1000 Display Stand
3 90039 2 3/8-16 x 1 Hex Cap Screw G5
ns = not shown
  • Page 1 1

Western 500 & 1000 Point of Purchase Display Stand #95631 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI