1
BEFORE USING THE WASHER
CAUTIONS
PRECAUTIONS WHEN OPERATING
In cas e of pump drained washer,
remove the cap-hos e from
the drain hole.
B e s ure that the was her is grounded.
To avoid electrical shock,us e
a metal pipe for the ground
connection. B ut, don't ground
the was her with gas pipes or
telephone lines to avoid to
dangers of explosion or lightning strike.
Do not put your hands into the s pin
dryer bas ket when it is s pinning.
Your fingers can be caught
by spinning laundry and
damaged.
Ventilation
opnning must not be obstructed
by carpeting when the was hing machine is
installed on a carpeted floor.
If the supply
cord of this appliance is damaged,
it mus t only be replaced by a repair shop
appointed by the manufacturer,because
special purpose tools are required.
To
avoid overfilling and damages this appliance
must be filled with the operator pres ent us ing a
moderate water supply press ure only.
Never allow children to operate
or play with the was her.
C hildren playing with the was her
may accidentally fall into the
was hing tub.
B e s ure to c over with the inner
cover on laundry before s pinning.
This prevents laundry from
being tossed out and damaged.
B efore was hing,c hec k all pockets .
If nails or pins remain in pockets,they may
damage the was her or clothes .
C los e the water tap a little if the
water pres s ure is too high.
To avoid water s plas hes ,
clos e the was h tub lid.
B e s ure lay the drain hos e down
(in cas e no drain pump)
Never s plas h water on the c ontrol panel.
Dis connec t the power cord from the
power s upply when not in us e.
Don't us e exc es s ively hot water.
(50ûC or more)
P lastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
SWT60H1-gbEq-01282A 22/09/03 7:50 PM Page 1
2
DESCRIPTION OF PARTS
INNE R L ID
When you open this lid while
the s pin basket is spinning,
the s pinning will be s topped
by breake system.
P OWE R C OR D
WATE R DR AIN HOS E
(WITHOUT P UMP )
DR AIN HOS E
(WITH P UMP )
S P IN DR YE R
B AS K E T
WAS H TUB L ID
Be sure to keep the lid
closed during washing
and spinning.
OVE R FL OW
FILT E R
S T R AINE R
(FILTE R )
WAS H TUB
P UL S ATOR
DR AIN F ILTE R
(with pump)
The plugÕs shape may not
correspond with this drawing.
1.WA S H TIME R
This is used to set the was h time, 1-15 minutes.
2.CY C L E S E L E C TOR
This is used to select the Washing /
R ins ing or draining
3. S PIN DR Y T IME R
This is used to set the spin time, 1-5 minutes .
4.WAT E R S E L E C TOR (F OR B TY P E )
During washing,WAT E R S E LE CTOR K NOB should
be selected to wash.During s pin rinsing,WATE R
S E LE C TOR KNOB should be selected to spin.
CONTROL PANEL
S P IN DR YE R L ID
FOR A T Y P E
FOR B T Y P E
SWT60H1-gbEq-01282A 22/09/03 7:50 PM Page 2
WASHING PROCEDURE
3
S P IN DR Y
1. B efore s tarting was hing, c hec k the following;
C onnect the water supply hose and open the water tap.
- Lay the drain hose down toward a sinkhole.
(In case no drain pump)
- P lace the drain hose in sink or bath.
(In case drain pump)
-C onnect the power cord to the power supply outlet .
2. S et the C YC L E S E L E C TOR K NOB to
‘WAS H
R INS E . (in case drain pump “W AS H )
4. F ill water in the was h tub
and add the detergent.
5. L oad laundry in the
was h tub and fill
water to H high
water level.
6. S et the WAS H TIME R 1-15minutes .
7. A fter was hing,s et the
C Y C L E S E L E C TOR K NOB
to ÔDR AINÕ for drain.
1. Trans fer the clothes into the s pin bas ket
and arrange the clothes evenly.
3. C los e the s pin dryer lid.
4. S et the S PIN DR Y T IME R 1-5minutes .2. B e s ure to attach the s afety cover and
clos e the inner lid.
inner lid
safty cover
3. S et the WATE R S E L E CTOR
K NOB to WAS H .
TO WAS H
FOR B T Y P E
SWT60H1-gbEq-01282A 22/09/03 7:50 PM Page 3
“
‘
‘
‘
ADDITIONA L R INS E
4
S et the W AT E R S E LE C T OR K NOB to
S P IN and C Y CLE
S E L E C TOR K NO B to
ÔDR AINÕ.
R INS ING
OVE R FL OW R INS E
1. S et the C Y C L E S E LE C TOR K NOB to
WAS H R INS E (In case drain pump “WAS H )
2. S upply the proper amount of water
as not to overflow the top of the
was hing tub.
3. S et the WAS H T IME R
2~3minutes .
3.As s oon as the WAS H T IME R
s huts off, turn off the water tap.
1.K eep s uppling water
4. Drain the water.
S et the C YC L E
S E LE C TOR
K NOB to DR AIN
5.R epeat this cycle until drain water
is clean. (2~3 cyc le)
2.S et the WA S H
TIME R 6~8minutes .
4. S et the C YC L E
S E LE C TOR K NOB
to ÔDR AINÕ.
1
2
3
4
5
6
inner lid
safety cover
After rinsing you can select this
cours e for more effective rinse
(Don't select only this course
for rinse.) Load the laundry
evenly into the s pin basket.
S upply water for about 1minute.
Adjust the water flow to prevent
overflow from the wash tub.
After s topping water
supply, cover the
laundry with safety cover
and close the inner lid.
C lose the spin dryer
lid.
S et the S P IN DR Y
TIME R 2~3 minutes.
(Without pump)
(with pump)
Adjust water pressure to ensure
that the amount of water supplied
does not exceed that water drained.
SWT60H1-gbEq-01282A 22/09/03 7:50 PM Page 4
‘
‘
“
‘
‘
C ONNE CT ING THE DR AIN HOS E
INSTALLATION
L eave s ome s pac e
S pace at las t 15cm between the was her
and the wall.
P lac e the was her on a s turdy flat s urface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2û)
Never ins tall the was her near water.
Do not place the washer in steamy rooms or
where the was her is directly exposed to rain.
Moisture may des troy the electrical insulation
and cause an electrical shock hazard.
Avoid direc t s unlight or heating devices .
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters , boilers,etc.
Do not place under direct sunlight.
CLEANING THE MACHINE
5
E NV IR ONME NT
1. OVE R F L OW F ILT E R
P ull the upper s ide of the
overflow filter with
your fingers into the holes
in the direction of arrow as
shown in the figure.
2. C L E ANING T HE F ILTE R
P ush the strainer(filter) out and take up the
filter as shown in figure.
Wash the filter and washing tub.
3. C L E ANING T HE WAS HE R B ODY
Wipe off s trains on the cabinet and operation panel with s oft cloth.
Do not us e benzene,thinners,cleans er,or wax, nor scrub the washer with a brush.
P ainted s urfaces or plas tic parts will be damaged.
1.
P lace a rag under the washer filter
not to wet the floor.
2.
R otate the filter counterclockwise
and pull out the filter.
3. R emove dirts and rotate
the filter clockwise until it
locks in position.
HOW TO C L E A N T HE F ILT E R (In cas e drain pump)
Install the drain hos e about
70~80cm above the ground
for pump model.
After press ing the joint ring(a), insert the drain hos e(b)
to drain direction.
a
b
SWT60H1-gbEq-01282A 22/09/03 7:50 PM Page 5
TR OUB LE
The was her
does not work.
C lothes will
not move freely.
Incomplete
s pinning
TR OUB LE
Incomplete
draining
The s pin dryer
bas ket will not
run.
C HE CK P OINT
C heck that the power cord is
connected to a power outlet well.
P ower s toppage?
Is the laundry overloaded?
Are the laundry arranged evenly?
WAS HING T IME
LAUNDRY GUIDE
MAINTENANCE
TROUBLE SHOOTING
6
S P IN DRY TIME
DE TE R GE NT
WHE N Y OU L OAD THE L AUNDRY INTO
THE S PIN B AS K E T.
P ress the laundry evenly and put the safety
cover into the spin basket drum as shown in
the figure.
K INDS OF C L OT HING
E xtremely solid heavy fabric
Linen,cotton,etc.
Ordinary clothes
(underwear,etc)
S lightly s olied synthetic
fiber
100%wool,mixed wool knitting,
thin synthetic fiber with tags
indicating hand was hing
WAS HING TIME
10 to15minutes
8 to10minutes
7minutes
2 to 5minutes
2 to 5minutes
TIME
1min.
1~2min.
3~5min.
5min.
TY P E OF L AUNDR Y
Thin(synthetic fiber)
wool
cotton
thick(cotton)
In case the water level is at High ,
amount of water is 42l.
-H-
Follow the directions printed on the
package for amount of detergent.
C hoose the amount of detergent
depending on the fabric type and
water level.
C HE CK P OINT
Is the filter c logged
with lint?
S ee ÒC leaning the
mac hineÓ on page 5.
Is the s pin dryer lid c los ed
completely?
Are laundry(s ocks ,etc.)falling
out of the s pin dryer bas ket and
clinging to the axle?
S ee ÒTo pick out...Ó
on page 6.
SWT60H1-gbEq-01282A 22/09/03 7:50 PM Page 6
‘
‘
‘
‘
B efore operating the unit, pleas e read this manual throughly,
and retain for future reference.
B E F O R E US ING T HE WAS HE R 1
C A UT IONS 1
P R E C A UT IONS WHE N OP E R AT ING 1
DE S C R IP TION OF PA R TS 2
C ONT R OL PA NE L 2
WAS HING P R OC E DUR E 3
TO WAS H 3
S P IN DR Y 3
R INS ING 4
OVE R F LOW R INS E 4
ADDIT IONAL R INS E 4
INS TA L L ATION 5
E NV IR ONME NT 5
HOW TO C LE AN T HE F ILT E R 5
C ONNE C TING DR AIN HOS E 5
C L E A NING T HE MA C HINE 5
L A UNDR Y G UIDE 6
MA INT E NANC E 6
TR OUB L E S HOOT ING 6
S P E C IF IC AT IONS
Owner's Ins tructions
SWT60H1-gbEq-01282A 22/09/03 7:50 PM Page 7
W715mmxD430mmxH870mm
0.05~0.78 MPa
0.5 ~ 8.0 kg.f/cm2
60 %
42 l
Was hing : 3.8 kg S pinning : 3.8 kg
Was hing : 280 W S pinning : 110 W
350 W
Was hing 1Hour S pinning 15minutes
IF Y OU NE E D HE L P.
Do not hes itate to call your local sams ung service center.
They will be willing to help you.
B e sure to give them your name,address ,telephone number and the purpos e of the call.
S P E C IF IC AT ION
DIME NS IONS (mm)
WATE R P R E S S UR E
WE IG HT
E XT R AC T ION E FF IC IE NC Y
S TANDAR D QUA NT IT Y OF WATE R
NOMAL C A PA C IT Y
MOTOR INP UT
MOTOR MAX INP UT
R ATING TIME
With out pump 19kg With pump 21kg
DC 68-01282A
SWT60H1-gbEq-01282A 22/09/03 7:50 PM Page 8
/
