Installs in 3 Easy Steps
Step 1: Remove the old showerhead by
turning it counterclockwise. Wipe off any debris
from the threaded pipe. Wrap the supplied
teon tape clockwise around the threaded pipe.
Step 2: Install the swivel bracket by turning it
clockwise, then tighten by hand. If additional
tightening is required, place protective cloth on
the swivel nut and tighten with a wrench.
Step 3: Attach the hose to the bracket, and
then to the handle. Now you are ready to enjoy
your Pollenex
™
Hand-Held Showerhead.
1 2 3
6 Spray Settings:
Full Body
Wide cone spray for
maximum coverage
Light Spray
Soft warm stream
Jet Massage
Oscillating massage
provides temporary relief
to tired, sore muscles
Aerated
Relaxing, wide
water stream mixed
with air bubbles for
sudsy shampoos
Light Spray
+ Jet Massage
Soft warm stream with
oscillating massage
Pause
Saves water while
shampooing