Toro Traction Hub, 824 Snowthrower Installation guide

Brand: Toro

Model: Traction Hub, 824 Snowthrower

Type: Installation guide

    

  

FORM NO. 3319–701

INSTALLATION

INSTRUCTIONS

PART NO. 98-2255

TRACTION HUB KIT

for 1997 824XL Snowthrowers Models 38083 & 38084

1. Remove eight screws securing back plate and

bottom plate (Fig. 1).

m-2682







Figure 1

1. Back plate

2. Bottom plate

3. Screw (8)

2. Remove master link and roller chain (Fig. 2).

3. Remove hex shaft assembly by removing four

bearing mounting screws (Fig. 2).

4. Remove friction wheel, traction hub and slider

ring from hex shaft (Fig. 2).

5. Remove friction wheel from hub by removing

four screws and lock nuts (Fig. 2).

6. Remove slider ring by removing snap ring and

thrust washer (Fig. 2).

IMPORTANT: If a burr prevents easy

disassembly of slider ring from traction hub,

the burr must be removed with a file to avoid

damaging the slider ring bushing.

7. Reassemble in reverse order, using all the new

parts included in this kit. Apply a coat of oil to

all sliding and rotating surfaces.

IMPORTANT: The standard thrust washer

goes between the slider ring and the traction

hub. The keyed thrust washer goes between

the slider ring and the snap ring (Fig. 2).

8. Refer to the Adjusting Traction Drive section in

your owner’s manual for adjustment information.

























Figure 2

1. Masterlink and roller chain

2. Hex shaft assembly

3. Bearing mounting screw (4)

4. Lock nut (8)

5. Friction wheel

6. Traction hub

7. Slider ring

8. Hex head screw (4)

9. Snap ring

10. Standard thrust washer

11. Keyed thrust washer

Toro Traction Hub, 824 Snowthrower Installation guide

Toro Traction Hub, 824 Snowthrower Installation guide

Toro Traction Hub, 824 Snowthrower Installation guide

Related papers

Other documents