Feiss FM404PN Installation guide

Type
Installation guide

This manual is also suitable for

1
Installation Instructions for
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
Secure the mounting plate to the electrical box with two mounting plate screws.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Place the fixture base onto the mounting plate studs and secure them in place by tightening the ball nuts.
Place the shade and spacer over the socket, then secure them in place by tightening the collar nut.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
1
2
1A
3
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
4
1
1
6
7
5
MOUNTING PLATE
Hounslow1 Light Flush Mount
1.1
F 404-FM408M
Ceiling
F 404, F 408MM
LAMP
FIXTURE BASE
7
SPACER
SHADE
5
4
3
1
6
COLLAR NUT
BALL NUT
MOUNTING PLATE STUD
4
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.969.3347
www.Feiss.com
© 2015 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Feiss FM404PN Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI