Gaxcoo Ring Sizer Mandrel Measuring Tool Iron/Steel/Plastic Gauge Finger Measurement Set User guide

Model: Ring Sizer Mandrel Measuring Tool Iron/Steel/Plastic Gauge Finger Measurement Set

When most of our customers are receiving their new Ring Sizer Kit, the next thing they

ask is what is the best way to use it?

Here are some tips you might want to know:

#1 Ring gauges - When placed on a finger, the ring must pass the finger joint

#2 Ring mandrel - Your size of a ring is determined using a ring sizing stick or ring

mandrel that is marked in quarter, half, and full-size increments (These increments

equate to inside diameter increases of approximately 0.2 mm, 0.4 mm and 0.8 mm

respectively).

#3 Ring mandrel - To do sizing work, bench jewelers use a steel ring mandrel made of

tapered, milled steel; and marked in quarter, half, and whole sizes (0.2 mm, 0.4 mm

and 0.8 mm, inside diameter respectively).

#4 Polishing cloths - Make sure at no point it gets wet, wrap it around the jewelry

piece or watch and simply rubbing it until it gets clean and polished

If you are not 100% satisfied, please contact us so we can make things right.

Best Regards,

Thomas

If you no longer wish to receive emails from Gaxcoo, unsubscribe.

Model: Ring Sizer Mandrel Measuring Tool Iron/Steel/Plastic Gauge Finger Measurement Set