14
1. Place the new power supply in the space provided in the case and mount it to the
rear with the four screws provided. Do not use excessive force.
2.Plugthe20/24pinconnectorintothesocketprovidedonthemotherboard.If
you have a 24 pin connector, put the remaining 4 pins in the right position before
pluggingtheconnectorintothesocket.Ifusinga20pinconnector,simplyleave
the additional 4 pins on the side.
3.Nowconnectthe4pinconnector,alsocalledtheP4connector,intothesocket
provided on the motherboard. This connector is going to supply your PC with
additional power.
4. If required, plug the PCIe connector to your graphic card.
6. TROUbLESHOOTING
Please note:
InATXsystems,thepowersupplyreceivesasignalfromthemotherboardwhen
switched on, without which it cannot run. For this reason, please ensure that the
power switch connector (usually located on the front panel) is correctly connected
to the motherboard using either the motherboard or case manual. If this is the
case,checkthepower(on/o)switch,asitmaybefaultywhichmeansthepower
supply cannot be started. You can use the reset switch instead of the power switch
in order to avoid such faults.
Careful!
Workingonpowersourcescouldleadtoseriousinjury.Youmustreaditem2–
„Warningsandsafetyinstructions“carefully.Repairsmustonlybecarriedoutby
authorised technicians!
If the system does not function properly with the power supply installed, rst
checkthefollowingpossiblesourcesoffaults:
A.Check that the power supply cable is correctly and rmly connected to the
power supply and tothe socket. Ideally,use aseparate poweroutletfor the
computer power supply.