Ohlins FGOH1090 Mounting Instruction

Öhlins Front Fork Kit for Öhlins 48

FGOH 1090

Application Speciﬁc Mounting Instructions

Issued 2009-12-01

Kit Contents (application speciﬁc)

Recommended Tools (application speciﬁc)

Hydraulic Stop Cup

Set-Up Data

Spring Recommendation

Part No. Pcs.

Front Fork kit FGOH1090 1

Base plug (with o-rings) 15430-05 2

Spacer 2 mm 15443-02 20

Hydraulic Stop Cup 15456-02 2

Spring Support washer N/A N/A

Öhlins Fork Cap Tool 01761-02

Socket for Öhlins fork Base Plug 17 mm

Socket for Öhlins Cartridge Base Plug 20 mm

FGOH 1090 Cartridge kit comes with an Öhlins hydraulic Stop

Cup that shall be installed according to step 10 in the Owners

Manual/General Mounting Instructions.

Rebound Damping 15 clicks

Compression Damping 15 clicks

Spring Preload 0 mm

Fluid Volume (each leg) 0,360 litre

Cartridge Kit FGOH 1090 shall be used together with

Öhlins Front Fork Springs part no. 08765-xx. For rate

recommendations, see Owner’s Manual/ General Mounting

Instructions.

Note!

The fork springs need to be ordered separately depending on the

rider’s choice of spring rate.

Part No. Pcs.

Circlip 15440-01 2

Öhlins Sticker 00197-01 2

TTX Cartridge Sticker 00191-29 2

Spring preload range -2 to 8 mm

(can be adjusted by adding/removing washers 15443-02)

Fluid volume range (each leg) 0,300 - 0,400 litre

Öhlins Front Fork uid 01312-01