2. Onn
  3. 100027961
100027961

Onn 100027961 User guide

  • Hello! I have analyzed the product guide for the onn. TV Wall Mount model 100027961. This document details the installation process for mounting a 50" to 86" television, including steps for both wood stud and concrete wall types. I'm ready to assist you with any questions you have regarding this mount or its installation.
  • What is the minimum size of the wood stud for installation?
    What is the minimum thickness of a concrete wall for installation?
    Can I install this mount on the ceiling?
Mar. 8, 2021_V2
Attach both TV Brackets
Screw and Washer
Spacer, Screw and Washer
4
Choose proper screws that fit your particular TV mounting holes. Use spacers and washers as
needed since they are not always required. You will have screws, spacers and washers leftover.
Discard all unused hardware after you have completed TV mount installation.
Remove Inner Circle
Select TV Screws
P
P
O
OO TV back
TV bracket Washer
TV bracket
Long Screw
Spacer
TV back
Need Spacer?
Short Screw
Washer
CAUTION: Carefully lay your TV on its face on a flat, non-abrasive surface covered with
blanket or soft padding to help prevent damaging the screen.
CAUTION: Place left and right TV bracket in the appropriate position, make sure they are
CENTERED on the back of TV and LEVEL with one another.
▪ No, go to below for detailed combination.
▪ Yes, go to below for detailed combination.
M4 M8
(actual size shown)
M6
P
Attach TV Brackets to TV
Tips: If you need to combine , or screw with M4/M8x2.5mm spacer , you have to
remove the inner circle of M4/M8x2.5mm spacer .
For wood stud installation, follow STEP 2A
For concrete wall installation, follow STEP 2B
Wood Drill Bit
7/32" (5.5mm)
2.5" (64mm)
CAUTION: The wood stud minimum size is 2x4", and surface covering can't be
more than 5/8". Drill hole on the wood stud center line.
NEVER USE ANCHOR FOR WOOD STUD ASSEMBLY
5
Wood Stud Installation
Level
Hold Hanging template at desired
position, use a pencil to mark 4 hole
locations.
Pre-drill marked 4 holes by 7/32"
Wood Drill Bit to a depth of 2.5".
Fix Wall plate unit to the wall with
M8x60mm Lag bolts .
Center line 16"/24"
Stud
Finder
Confirm wood stud location with stud
finder.
Socket Set
1/2" (13 mm)
MIN: 5.5" (140mm)
2.5" (64mm)
6
Level
DANGER
Hold Hanging template against
wall at desired position, use a pencil to mark
4 hole locations.
Pre-drill marked 4 holes by 3/8" size
Masonry Drill Bit to a depth of 2.5".
Insert Anchors into wall and use
hammer to lightly tap them into wall.
Fix Wall plate to the wall with
M8x60mm Lag bolts .
Socket Set
1/2" (13 mm)
Concrete, Stone or Masonry Installation
CAUTION: The concrete wall minimum thickness is 5.5", and surface covering can't be more
than 3/8".
CAUTION: These anchors are for concrete, stone or masonry wall ONLY. Do not install into
wood stud.
CAUTION: This product can only be installed on a perpendicular wall. Do not install this
product on the ceiling.
Masonry Drill Bit
3/8" (10mm)
18 1 1 3 1 3 1 2 4 3
6
Mar. 8, 2021_V2
/