2. HAVIT LIGHTNING
  3. HV4002T-2-BLK Revo Spot Light

HAVIT LIGHTNING HV4002T-2-BLK Revo Spot Light User manual

  • Hello! I've reviewed the installation instructions for the Havit Revo spot lights (models HV4002T-2-BLK and HV4002T-2-WHT). This document outlines the specs, safety measures, and step-by-step installation instructions. I'm ready to answer any questions you may have about the device, such as how to adjust the color temperature or understand the warranty information and the safety requirements.
  • What is the IP rating of the Revo spot light?
    What is the input voltage for the Revo spot light?
    What color temperatures can be selected?
    What is the warranty period?
Product Specications
Model No. HV4002T-2-BLK HV4002T-2-WHT
Name Revo
Material Aluminium
Colour Black White
IP Rating IP20
Input Voltage 240v AC
Protection Class 1(Requires Earth)
Lamp Base Built in LED
Lamp Wattage 2x 8w
Colour Temp TRI Colour - 3000k, 4000k, 5500k
Lumens 2x 640lm,2x 680lm, 2x 720lm
CRI >80+
Wiring Parallel
Dimmable Yes
Warranty 3 Years Replacement*
Dimensions
55 350
110
30
Ø55
90° Tilt | 270° Swivel
160
Contact Details: Warranty Terms & Conditions*
Revo Spot Light Installation Instructions
143 Beauchamp Road
Matraville NSW 2036
Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: [email protected]
Web: www.havit.com.au
Important Safety Issues:
• This product must be installed by a qualied electrician according to AS/NZS
3000.
• Ensure all electrical mains are disconnected before any installation.
• Modication of this product will void any warranty.
• Havit Lighting does not take responsibility for wrong installation, incorrect
use, or use of installation material that does not belong to the system.
• Aluminium and 304SS ttings must not be installed within 5km of any salt
water environments.
• All o-rings and seals must be in place correctly to maintain warranty
• This form may be updated at any time due to product improvements, please
check online installation form for most current version.
Must be installed by a licensed electrician
Additional Information
Steps for Installation:
1. Make sure that the electrical circuit is free of voltage (master switch o)
2. Remove allen screws on side of tting and set aside.
3. Install base plate in desired location
4. Connect the cable - use wire with earth; connect the earth rst, then live and neutral wire
5. Fitting is preset to 3000k, to change slide switch to desired colour temperature
6. Reattach iting to base plate making sure allen screws are tight.
7. Adjust tting to desired position making sure to stop rotating when tting cannot rotate anymore, If forced tting will continue to rotate and cause internal cables to become
entangled causing tting to short. If this is done, warranty will be voided.
8. All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Mounting Base Diagram
N
Dimensions
336
Ø20 2x Ø4
15
41 50
104 104
/