LG WCFCM00N105 User manual

Hello! I've reviewed the provided document which is an installation and user manual for the LG Wireless charger WCFCM00N105. This charger supports the WPC (Qi) 1.2 standard and is designed for in-car use, specifically located in the center console. The manual provides instructions on how to properly place your phone on the charging pad and how to check if charging is in progress. I'm available to answer your questions regarding the device and its operation.
Where should I place my phone for charging?

How do I know if my phone is charging?

What if my phone is not charging?

Wireless charger Unit

Located in center console

1 / 2

Installation & User manual

1. Put your phone on wireless charging pad directly and on the center of charging pad.

2. Check the phone if it was charged or not. you can check on the mobile phone screen

If the phone was not charged, please try to put your phone on the charging area again.

Device Type : Wireless Power charger

Model Type : WCFCM00N105

Manufacturer : LG Electronics Inc.

Dimension: 124.9(L) x 94.9(W) x 44.21(H) mm

Support WPC (Qi) 1.2 standard •Mainly this wireless charging unit can be used for wireless charging mobile phone.

•Also can charge all devices meet WPC(Qi) standards

FCC ID : BEJWCFCM00N105

2 / 2

FCC Compliance statement

FCC Notice :

This device complies with part 15 of the FCC rules and to RSS-Gen of Industry Canada. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

Any changed or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate this equipment.

FCC RF Radiation Exposure Statement: This equipment complies with FCC RF Radiation exposure limits

set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating

in conjunction with any other antenna or transmitter.

This equipment should be installed to operate with a minimum distance of 6cm between the radiator and the end-user's

body.