2. Simply45
  3. S45-1710S
S45-1710S

Simply45 S45-1710S User manual

  • Hello! I am an AI chatbot trained to assist you with the Simply45 S45-1710S User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What are the supported cable diameters for this plug?
    What types of LAN cables are suitable for this plug?
    How should I prepare the cable before plugging it into the connector?
    Is the nylon cable bushing reusable?
    What should I do if the drain wire is stuck between the housing and cover?
    How do I complete the installation process?
Instruction Manual
White/Orange
Orange
White/Green
Green
White/Green
Green
Blue
White/Blue
Blue
White/Blue
White/Brown
Brown
White/Orange
Orange
White/Brown
Brown
JACK PIN
DESIGNATIONS
1
2
3
6
4
5
7
8
TIA / EIA
T568B
Yellow
Orange
White
Blue
INDUSTRIAL
TIA / EIA
T568A
Follow the color-coded wire pattern label
and align each conductor into proper slot
on wiring cap. Using flush cutter,
trim wires flush with wiring cap.
1
Remove wiring label before placing wiring
cap on connector.
Place wiring cap onto IDC terminal and press firmly
down. Ensure drain wire or braiding is in contact with
grounding clip. See illustration.
Make sure drain wire is not stuck
between housing as you close
plug cover firmly down. Screw on
the cable gland with inserted
bushing to complete installation.
34
5
2
Unload the cable
Wiring Label
10G Rated RJ45 Field Plug - Ultra Slim –
Fully Shielded for Cat6/6a/7a Shielded LAN
cables, Toolless, 1 Piece Design, Re-usable.
ISO/IEC 11801, Class Fa, F, Ea, E, ANSI/TIA 568.2-D,
PoE/PoH IEEE 802.3bt Type 1-4
Supports cable diameter: 6.0 - 9.0 mm
S45-1710S
8mm
30mm
8mm
30mm
5mm
50mm
OD Φ8~9mm
(No folded braiding)
Drain wire and braid
Grounding clip
OD Φ6.1~7.9mm
OD Φ5~6mm
T568A T568B
INDUSTRIAL
T568A T568B
INDUSTRIAL
T568A T568B
INDUSTRIAL
Open Plug Cover
Release Wiring Cap
Release Cable gland
Drain wire and braid cannot excess housing
Ensure drain wire and braid are not stuck between housing and cover
Cable Bushing
Cable Preparation
Slide metal cable gland with black nylon
cable bushing onto the cable. Follow cable
preparation as shown. Fan out all 4
twisted pairs and cut the conductors as shown.
Note:
a. Make sure nylon cable bushing is facing correctly
as shown to the right.
b. Nylon cable bushing has slit to allow proper tightening during final
stage of screwing the metal cable gland to the connector.
Cable busing may be removed on cable OD >8mm.
Metal Cable Gland
/