Rowley RTMDCHCBP Owner's manual

Type
Owner's manual

Rowley RTMDCHCBP: High Capacity Battery Pack - The rechargeable Li-ion Battery Pack allows DC Tubular Motors to operate wirelessly and without the constraints of traditional battery wands. It provides up to 500 up/down cycles on a single charge, recharges in 6 hours, and can be paired with the optional Solar Panel Battery Charger for continuous recharging. Its small profile allows for optimal placement in the window pocket and its battery health status can be monitored in the R-TEC Automation® App.

Rowley RTMDCHCBP: High Capacity Battery Pack - The rechargeable Li-ion Battery Pack allows DC Tubular Motors to operate wirelessly and without the constraints of traditional battery wands. It provides up to 500 up/down cycles on a single charge, recharges in 6 hours, and can be paired with the optional Solar Panel Battery Charger for continuous recharging. Its small profile allows for optimal placement in the window pocket and its battery health status can be monitored in the R-TEC Automation® App.

© 2023 Rowley® Company. All rights reserved. R-TEC Automation® is a registered trademark of the Rowley® Company, LLC. 1
The small profile allows for optimal placement in the window pocket,
fully recharges in about 6 hours and can be paired with the optional
Solar Panel Battery Charger for continuous recharging.
High Capacity Battery Pack - The rechargeable Li-ion
Battery Pack enables DC Tubular Motors to operate
wirelessly and without the constraints of traditional battery
wands with disposable batteries.
FEATURES
Up to 500
Up / Down Cycles
on Single Charge
Recharges
in 6 hours
Battery Health
Status in R-TEC
Automation® App
Optional Solar
Panel for Continuous
Recharging
Small
Profile
1 2 3 4 5 6
500
High Capacity Battery Pack
RTMDCHCBP
© 2023 Rowley® Company. All rights reserved. R-TEC Automation® is a registered trademark of the Rowley® Company, LLC. 2
2 | Automate Rechargeable Battery Instructions | MTBPCKR-28 ROLLEASE ACMEDA
WARNING: Important safety instructions to be read before installation.
Incorrect installation can lead to serious injury and will void manufacturer’s liability and warranty.
CAUTION
Do not expose to moisture or extreme temperatures.
Do not allow children to play with this device.
Use or modification outside the scope of this instruction manual will void warranty.
Installation to be performed by a suitably qualified installer.
For use with DC powered Cord Lift, Tilt and tubular motors.
Ensure correct crown and drive adaptors are used for the intended system.
Use only Rollease Acmeda hardware.
Before installation, remove any unnecessary cords and disable any equipment not needed for powered operation.
Do not expose the battery to water or install in humid or damp environments.
Do not drill into battery body.
The routing of cable through walls shall be protected by isolating bushings or grommets.
Ensure cables are clear and protected from moving parts.
Do not use if any cables are damaged
Important safety instructions to be read prior to operation.
It is important for the safety of persons to follow the enclosed instructions. Save these instructions for future reference.
Persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge
should not be allowed to use this product.
Keep battery away from acid, alkali, heat & fire.
Do not dispose of in general waste.
Please recycle batteries and damaged electrical products appropriately.
SAFETY INSTRUCTIONS
SPECIFICATIONS
5005833
Input Volts 12.6V
Output Volts 12.0V
Capacity 2600mAh
Insulation Class III
Battery Size/Type 1-1/4” x 1-1/4” x 10” / Lithium-ion Rechargable
Temperature Working Range 32°F to 140°F (0°C to 60°C)
© 2023 Rowley® Company. All rights reserved. R-TEC Automation® is a registered trademark of the Rowley® Company, LLC. 3
3 | Automate Rechargeable Battery Instructions | MTBPCKR-28 ROLLEASE ACMEDA
1 INSTALLATION
Charging1.1
Step 1. Connect the Rechargeable Battery Pack
to the Rollease Acmeda charger.
Part #: MTDCB-CHARGE
Step 2. Charge for 6 hours.
Charging uses the 2 pin locking “SMR” style connector.
Step 3. Install as required.
See Section 1.2 Attachment Methods
Hook Screw Double Sided Tape*
Rechargeable Battery Pack must be fully charged prior to first
use to prolong battery lifespan.
Do not install Rechargeable Battery Pack where it will be
exposed to direct sun light.
*Not supplied
IMPORTANT
IMPORTANT
Attachment Methods1.2
Charging Cable
Connect the High Capacity Battery Pack
to the Battery Charger.
RTMDC18/25
RTMDC18/25
© 2023 Rowley® Company. All rights reserved. R-TEC Automation® is a registered trademark of the Rowley® Company, LLC. 4
4 | Automate Rechargeable Battery Instructions | MTBPCKR-28 ROLLEASE ACMEDA
ROLLEASE ACMEDA | AUSTRALIA
110 Northcorp Boulevard,
Broadmeadows VIC 3047
T +61 3 9355 0100 | F +61 3 9355 0110
ROLLEASE ACMEDA | USA
200 Harvard Avenue
Stamford, CT 06902 6320
T +1 203 964 1573 | F +1 203 964 0513
ROLLEASE ACMEDA | EUROPE
Via Conca Del Naviglio 18, Milan
(Lombardia) Italy
T +39 02 8982 7317 | F +39 02 8982 7317
info@rolleaseacmeda.com
rolleaseacmeda.com
DC Motor
Rechargeable Battery Pack
Solar Panel
Solar Panel
Charger
Solar Panel Y Cable
OPTIONAL
RECOMMENDED
OPTIONAL
Scenario Example using the Solar Panel Y Cable
Motor Connections
1.4
1.3
After first full charge, battery condition can be
maintained through the use of an optional solar
panel.
BEST PRACTICE
Motor Connection Cable
Cord Lift
MTDCRF-CL-0.6-50
Tilt Blinds
MTDCRF-TILT-1
Tubular Motors
Charging uses the 2 pin, non-locking “JST” style connector.
MTDCRF25-1.1
MTDCRF18-0.2 MTDCRFQ28-2
MT01-1225-069002 MT01-1228-069002
Any Questions?
Contact our R-TEC Automation® in-house experts at 866.985.3423. Email us at RTECAutomation@RowleyCompany.com.
RTMDCZ25
RTMDCZ28
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Rowley RTMDCHCBP Owner's manual

Type
Owner's manual

Rowley RTMDCHCBP: High Capacity Battery Pack - The rechargeable Li-ion Battery Pack allows DC Tubular Motors to operate wirelessly and without the constraints of traditional battery wands. It provides up to 500 up/down cycles on a single charge, recharges in 6 hours, and can be paired with the optional Solar Panel Battery Charger for continuous recharging. Its small profile allows for optimal placement in the window pocket and its battery health status can be monitored in the R-TEC Automation® App.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI